X10 MT13A Owner's Manual
  1. Manuals
  2. Brands
  3. X10 Manuals
  4. Timers
  5. MT13A
  6. Owner's manual

X10 MT13A Owner's Manual

X10 mini timer owner's manual
Hide thumbs
Table of Contents

Advertisement

Quick Links

Model MT13A
Mini Timer
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MT13A and is the answer not in the manual?

Questions and answers

Summary of Contents for X10 MT13A

  • Page 1 Model MT13A Mini Timer Owner's Manual...

  • Page 2: Table Of Contents

    Channel number 1 also activates an internal buzzer so you can us it as an alarm Troubleshooting ....................16 clock too! You can program up to 8 X10 Modules from the Mini Timer and you also have instant control of 8 Modules.

  • Page 3: Introduction

    NOTE: you must use the power supply that came with the Mini Timer. Modules, after selecting desired number button. The power supply contains circuitry required to control your X10 modules, so you CANNOT replace it with a regular 12V power supply.

  • Page 4: How To Program A Timed Event

    Security. If neither Once nor Security is displayed, the event happens at the same time every day. 1. Install and set up all of your X10 Modules referring to the instructions included with them. Be sure to turn off the power at the main circuit breaker panel when installing Wall Switch Modules.

  • Page 5: Programming On And Off Times

    Setting up the Mini Timer Programming ON and OFF times Setting something to happen every day at the same time Setting a timed event to occur Once only After you have installed all of your Modules and checked that they are working instantly If (within 4 seconds after setting an On or Off time) you press the “Mode”...

  • Page 6: Reviewing Timer Events

    Programming ON and OFF times Programming ON and OFF times Reviewing timer events If the display shows FULL Set the Mode Switch in the “Prog Set/Review” position. If no events exist in memory 0:00 is If FULL is displayed when you try to enter a programmed time, this means that you have displayed, otherwise the fi...

  • Page 7: Alarm Settings

    To Cancel/Snooze the wake-up alarm When you fi rst plug in the Mini Timer it controls X10 Modules set to Housecode A. If you When the alarm sounds at the time you have set, you can cancel it in one of two ways: want to change the Housecode: 1.
  • Page 8 Code setting on the Module. If the Module turns On and Off you can unplug the Module or Timer and move it to its permanent location. Mini Timer and move it to its permanent location. If you can’t control the module, contact www.x10.com/support for help. If you can’t control the module, contact www.x10.com/support for help.

  • Page 9: Troubleshooting

    Mini Timer when the intercom is in use. If the Intercom system has its A wide range of switch and control modules are available from X10, all of which can be own separate wiring it will not cause a problem.
  • Page 10 NOTES NOTES...
  • Page 11 120 days from the original date of purchase at retail. X10 agrees to repair or replace, at its sole discretion, a defective product if returned to X10 within the warranty period and with proof of purchase. If service is required under this warranty:...

Table of Contents