Tip
•
You can re-scan to update the list of stored stations
(see "Use DAB menus" > "Re-scan for stations").
•
You can tune to a station manually (see "Use DAB
menus" > "Tune to a station manually").
Tune to a stored station
1
Switch the source to
» The last listened station is broadcast.
2
/
Press
then press OK to start listening.
Note
•
If ? is displayed before the name of current station, the
station is unavailable or inactive.
Program radio stations
1
Tune to a DAB radio station.
2
Press PROG to activate the programming.
3
Press
/
to select a preset sequence
number.
4
Press PROG to confirm.
» The radio station is stored with the
selected sequence number.
5
Repeat steps 1-4 to program more radio
stations.
•
To tune to a preset radio station, press
until its name is displayed.
Note
•
If you store a radio station with the sequence number
of another one, the earlier one is overwritten.
.
to select a station, and
Display DAB information
Press DISPLAY repeatedly to cycle through the
following information (if available).
•
Dynamic label segment (DLS)
•
Signal strength
•
Program type (PTY)
•
Ensemble name
•
Frequency
•
Signal error rate
•
Bitrate codec
•
DAB/DAB+
•
Time
•
Date
Use DAB menus
1
In DAB mode, press MENU to access the
DAB menus.
2
Press
menus.
Re-scan for stations
Full scan is used to perform a wide range
search for DAB radio stations.
Press OK to start scanning for available DAB
stations.
» After the scanning is complete, the first
detected station is broadcast.
/
Tune to a station manually
With this feature, you can tune to a specific
channel/frequency manually. In addition to
antenna orientation for better radio reception,
the optimal reception can also be obtained with
this feature.
/
to toggle through the
EN
15