Related Manuals for Seagate ST500UM001
Summary of Contents for Seagate ST500UM001
- Page 1 Laptop Thin SSHD SATA Product Manual Standard models ST500UM001 ST320UM001 100725146, Rev. E Gen 1 - September 2015...
- Page 2 Publication number: 100725146, Rev. E September 2015 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. 3D Defense System and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. All other trademarks or registered trademarks are the property of their respective owners.
-
Page 3: Table Of Contents
Seagate® Technology Support Services ........ - Page 4 Mounting Dimensions (for standard models) ........... 17 Seagate Laptop Thin SSHD SATA Product Manual, Rev. E...
-
Page 5: Seagate Technology Support Services
For information regarding online support and services, visit: http://www.seagate.com/contacts/ For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/seagate-recovery- services/recover/ For Seagate OEM, Distribution partner portal and reseller portal, visit: http://www.seagate.com/partners/ Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... -
Page 6: Introduction
Introduction Introduction ® Laptop Thin SSHD This manual describes the functional, mechanical and interface specifications for the following Seagate model drives: Standard models ST500UM001 ST320UM001 These drives provide the following key features: 5400-RPM spindle speed. 64MB buffer. 16GB NAND flash ... -
Page 7: Drive Specifications
5% to 95% (nonoperating) Relative humidity gradient 30% per hour max 37.7°C max (operating) Wet bulb temperature (max) 40.0°C max (nonoperating) Altitude, operating –304.8 m to 3048 m (–1000 ft to 10,000+ ft) Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... -
Page 8: Formatted Capacity
Configuring and Mounting the Drive on page 16 Refer to (words 60-61 and 100-103) for additional information about 48-bit addressing support of drives with capacities over 137 GB. Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... -
Page 9: Physical Organization
However, due to the manner in which these drives are formatted, benchmark tests that include command overhead or measure logical seeks may produce results that vary from these specifications. Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... -
Page 10: Start/Stop Times
During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Standby power is measured at steady state (after 200ms from transition) Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... -
Page 11: Conducted Noise
Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave injected noise at up to 10 MHz. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current. 2.7.3 Voltage tolerance Voltage tolerance (including noise): +5V ± 5% Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... -
Page 12: Power Management Modes
In both Idle and standby mode, the drive accepts all commands and returns to active mode when disk access is necessary. Environmental Specifications This section provides the temperature, humidity, shock, and vibration specifications for Seagate Laptop Thin SSHD drives. Ambient temperature is defined as the temperature of the environment immediately surrounding the drive. -
Page 13: Shock
Test for prominent discrete tones (PDTs) Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses the lower limit for the threshold curve* to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards. -
Page 14: Electromagnetic Immunity
From this page, click on the “Is my Drive under Warranty” link. The following are required to be provided: the drive serial number, model number (or part number) and country of pur- chase. The system will display the warranty information for the drive. Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... -
Page 15: Agency Certification
Equipment (ITE). Emission levels are defined by EN 55022, Class B and the immunity levels are defined by EN 55024. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. -
Page 16: Environmental Protection
Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corrosive chemicals as electronic drive component reliability can be affected by the installation environment. The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%. -
Page 17: Configuring And Mounting The Drive
Figure 2 Attaching SATA Cabling Signal connector Power connector Signal cable Power cable Each cable is keyed to ensure correct orientation. Seagate Laptop Thin SSHD SATA drives support latching SATA connectors. Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... -
Page 18: Drive Mounting
.230 in 3.567 in 5.84 mm 90.60 mm .551 in 13.99 mm .263 in 6.68 mm 2.430 in 61.72 mm .160 in 4.06 mm For reference only. May not represent actual drive. Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... -
Page 19: Serial Ata (Sata) Interface
Hot-Plug Compatibility Seagate Laptop Thin SSHD SATA drives incorporate connectors which enable users to hot plug these drives in accordance with the Serial ATA: High Speed Serialized AT Attachment specification revision 2.0. This specification can be downloaded from www.serialata.org. This device requires a COMRESET from the host after a hotplug event. -
Page 20: Supported Ata Commands
Set Max Features register as defined to the right. Password: Lock: Unlock: Freeze Lock: Set Max Address Ext Set Multiple Mode S.M.A.R.T. Disable Operations B0h/D9h S.M.A.R.T. Enable/Disable Autosave B0h/D2h Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... - Page 21 ATA-standard power-management commands Check Power Mode Idle Idle Immediate Sleep Standby Standby Immediate ATA-standard security commands Security Set Password Security Unlock Security Erase Prepare Security Erase Unit Security Freeze Lock Security Disable Password Seagate Laptop Thin SSHD SATA Product Manual, Rev. E...
-
Page 22: Identify Device Command
The maximum value that shall be placed in this field is ST320UM001 = 0FFFFFFFh 0FFFFFFFh. The 0FFFFFFFh value applies to all capacities over 137GB (see Section 2.1 for related information). Retired 0000 Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... - Page 23 The mandatory value of the world wide name (WWN) for the drive. NOTE: This 108-111 Each drive will have a unique value. field is valid if word 84, bit 8 is set to 1 indicating 64-bit WWN support. Seagate Laptop Thin SSHD SATA Product Manual, Rev. E...
- Page 24 Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Seagate Laptop Thin SSHD SATA Product Manual, Rev. E...
-
Page 25: Set Features Command
Disable the Free Fall Protection feature (41 above enables the Free Fall Protection feature) Report full capacity available At power-on, or after a hardware or software reset, the default values of the features are as indicated above Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... -
Page 26: Commands
S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the command is aborted and 0x 04 (abort) is written to the Error register. Seagate Laptop Thin SSHD SATA Product Manual, Rev. E... - Page 27 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100725146, Rev. E...
Need help?
Do you have a question about the ST500UM001 and is the answer not in the manual?
Questions and answers