Table of Contents
Advertisement
appliance in a garage or an unheated
room without having to worry about
frozen food in the freezer being spoilt.
However at low ambient temperatures
mentioned above, fridge contents are
likely to freeze, so check and consume
food in the fridge accordingly. When
the ambient temperature returns to
normal, you may change the setting to
suit your needs.
3. Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance to
more electricity. If installed next to a
source of heat or freezer, maintain the
following minimum side clearances:
From Cookers 50 mm (2")
From Radiators 300 mm (12")
From Freezers 25 mm (1")
4. Make sure that sufficient room is
provided around the appliance to
ensure free air circulation.
Fit the two plastic wall spacers
supplied with the appliance onto
the condenser on the back of the
appliance by rotating 1/4 turn(See
Diagram).
5. The fridge/freezer should be located
on a smooth surface. The two front
feet can be adjusted as required. To
ensure that your appliance is standing
upright adjust the two front feet by
turning clockwise or anti-clockwise,
until the product is in firm contact with
the floor. Correct adjustment of feet
avoids excessive vibration and noise.
6. Refer to cleaning and care section
to prepare your appliance for use.
A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, near to of the compressor.
(See diagram) Gently remove the plug
from the receptacle. Never pull the
mains cord, you may damage the
appliance. In the case of
transportation, ensure you locate the
plug in the receptacle provided to
avoid transit damage.
REPLACING THE INTERIOR
LIGHT BULB
Should the light fail to work, proceed
as follows.
1. Switch off at the socket outlet and
pull out the mains plug.
• You may find it useful to remove
shelves for easy access.
2. Use a flat tipped screwdriver to
remove the light diffuser cover by
inserting the blade in each of the two
recesses to prise off each side.
3. First check that the bulb hasn't
worked loose by ensuring it is screwed
securely in the holder. Replace the
plug and switch on. If the bulb works,
replace the light cover by inserting the
8
EN
Hide quick links:
Advertisement
Table of Contents
