Wired LAN Related
Q
<Wake On LAN> function
A <Wake On LAN> is a function that activates the
system from Sleep mode when a signal (such as
a ping or magic packet command) arrives over the
network (wired LAN).
To use <Wake On LAN> function:
Click My Network Places > View network
connections from the Left Panel.
Click the right button on the touchpad over
Local Area Connection, and select Properties.
Click Configure, and select Power
Management tab. Select "Allow this device to
bring the computer out of standby", then click
OK. Restart the system.
– The LAN LED may not be turned off if System is
shutdown without disabling the <Wake On LAN>
option.
– If the system wake up from Sleep mode even
though there is no received signal, use the system
after disabling the <Wake On LAN> function.
– Connecting wired LAN while using a wireless LAN
may not activate the <Wake On LAN> function.
Configure Wireless LAN to "Disable" to use <Wake
On LAN> function.
Click My Network Place> View network
connections from the Left Panel.
Right-click over Wireless Network Connection
and select Disable.
Q
When I connected 100Mbps wired LAN and
the computer exits standby/hibernate mode,
a message informing 10Mbps wired LAN
connection appears.
A When the computer exits standby/hibernate mode,
restoring the network takes about 3 seconds. When
the network is restored, it operates in 100Mbps.
11