Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Intergraph G95
- Page 1 G95 Display Adapter for InterPro-27 Installation and Use August 1997 DHA021900...
- Page 2 The software discussed in this document is furnished under a license and may be used or copied only in accordance with the terms of the license. No responsibility is assumed by Intergraph for the use or reliability of software on equipment that is not supplied by Intergraph or its affiliated companies.
- Page 3 Installing the G95 Display Adapter Installation of the adapter consists of installing a 2 MB or 6 MB memory module (if not already installed) on the G95 board and installing the board itself. You can also install two boards for dual- screen capability.
- Page 4 Install the Memory Upgrade If the G95 board does not already have the required 2 MB or 6 MB memory upgrade, perform the following procedure. If the memory upgrade is already installed, skip this procedure and see the “Install the Boards” section below.
- Page 5 Installing the G95IP27 Video Display Driver The G95 adapter uses the G95IP27 video display driver. If you do not have a diskette containing the display driver or if the diskette is damaged, you can obtain a copy of the driver from Intergraph Online at http://www.intergraph.com/drive_update.stm or the Intergraph Bulletin Board Service (IBBS) at...
- Page 6 Configure the G95IP27 Video Display Driver NOTE The following procedure addresses only the MGA Settings tab on the Display Properties dialog box. To configure the G95IP27 Video Display Driver: Right-click the desktop, then click Properties. Click the MGA Settings tab on the Display Properties dialog box. Do the following: −...
- Page 7 BIOS from another source. The adapter’s video BIOS has been modified for use with the specified 27- inch monitor. Check the Intergraph Online or the Intergraph Bulletin Board Service (IBBS) for any future updates to the driver and to the video BIOS.
Need help?
Do you have a question about the G95 and is the answer not in the manual?
Questions and answers