Mitsubishi DLP XD8600U User Manual page 46

Adjusting projected images (continued)
ZOOM(V)
The vertical image size is adjusted using the center of the image as the base point. The setting range is 50% to
500%.
HORIZ. POSITION
Use to adjust the horizontal position of the projected image. The setting range is -999 to +999.
VERT. POSITION
Use to adjust the vertical position of the projected image. The setting range is -999 to +999.
RASTER POSITION(H)
When the supplied image is not projected on the entire display area, the horizontal location of the projected image
can be adjusted within the area. The setting range is -512 to +512.
RASTER POSITION(V)
When the supplied image is not projected on the entire display area, the vertical location of the projected image can
be adjusted within the area. The setting range is -384 to +384.
RESET
Press the ENTER button to reset the USER settings.
Important:
• Noise may appear on the screen depending on the combination of the type of the video signal being projected
and the setting values of the ZOOM(H), ZOOM(V), HORIZ. POSITION, VERT. POSITION, RASTER POSITION(H),
and RASTER POSITION(V). In such cases, set these values in the range where the image is displayed without
noise.
Saving the setting in the SIGNAL MEMORY:
You can save the settings of the SIGNAL menu using the SIGNAL MEMORY.
• You can save multiple signal settings for one signal format and switch the method according to use.
Up to 8 settings can be saved. (See page 31 for menu setting.)
[Example]
AUTO
SIGNAL menu ANY SIGNAL
To save the setting in the SIGNAL MEMORY:
1. Display the SIGNAL menu.
2. Select SIGNAL MEMORY while AUTO is selected in the MEMORY CALL by pressing the  or  button.
3. Select MEMORIZE
4. Select your desired memory number by pressing the  or  button.
5. Press the ENTER button to save the memory.
To save the new setting, select a new memory number. The memory number of the MEMORY CALL changes to a
•
new one after saving the setting.
• When the setting in the selected memory number is changed, the changed setting is automatically saved.
To select the saved memory by the MEMORY CALL:
You can call up and switch the setting saved in the SIGNAL MEMORY.
1. Display the SIGNAL menu.
2. Select MEMORY CALL by pressing the  or  button.
3. Select your desired memory number by pressing the  or  button.
• Only the memory number relevant to the input signal can be selected.
• When the same signal is input on the next time, the selected memory number is still memorized.
1-720p50 2-720p50
720p50 720p50
and press the ENTER button.
Memory number in the SIGNAL MEMORY
3-1080i60
1080i60
EN-46
4-xxx •••
-
8-xxx
-