AEG HG755820UM User Manual page 13

multiple connection. Make sure that
the ground connection agrees with
the standards and regulations.
• Do not let the power cable to heat up
to a temperature higher than 90° C.
To prevent contact between the cable
and the appliance below the hob use the
clamps which are on the side of the
cabinet.
A
A) Rigid copper pipe or flexible pipe of
stainless steel
8.4 Connection cable
To replace the connection cable use only
the special cable or its equivalent. The
cable type is: H05SS-F T180.
Make sure that the cable section is
applicable to the voltage and the
working temperature. The yellow / green
earth wire must be approximately 2 cm
longer than the brown (or black) phase
wire.
8.5 Building In
min.
150 mm
min.
55 mm
30 mm
490 mm
8.6 Installing hob under the
hood
8.7 Possibilities for insertion
min.
650 mm
The panel installed below the hob must
be easy to remove and let an easy access
in case a technical assistance
560 mm
intervention is necessary.
CAUTION!
Install the appliance only on
a worktop with flat surface.
If you install the hob under a
hood, please see the
installation instructions of
the hood for the minimum
distance between the
appliances.
The burner flame may be
extinguished by an air flow,
if the removable panel is not
installed. The air flow may
occur when you open or
close the cabinet door or
drawer.
ENGLISH 13