Advertisement
6.
Plug the AC adaptor into the back of the Receiver and the wall outlet.
7.
Straighten the antenna vertically.
8.
Adjust the volume control knob on the back of the Receiver. You may turn
the sound off and use only the LED light if you wish.
9.
When you press the reset button down to turn off the red light, do not hold
it down for more tham 1-2 seconds. Just press down and let up.
Curb Side
2
3
1
4
Set dial on # 4 - Mount with arrows on Transmitter
pointing up towards the top of the mailbox door.
( Arrows should point towards you when you open the door )
Wall Mounted
2
3
1
4
Set dial on # 3 - for mailboxes with large tapered lids.
Mount with arrows on Transmitter pointing up.
Set dial on # 2 - for mailboxes with short tapered lids and flat tops.
Mount with arrows on Transmitter pointing up.
AC Adaptor
Volume control knob
Receiver
Set knob
on # 4
Set knob
on # 2 or 3
Slot Type
Set dial on # 4 - Mount with arrows
on Transmitter pointing up towards hinge.
Trouble shooting
1. Check if you mounted the Transmitter correctly on your mailbox.
2. For a curb side mailbox, check if the arrows point towards you when
you open the mailbox door.
3. Check if the battery is installed correctly.
4. Move the receiver to a different location.
5. Your mailbox must be level. However, if it leans forward a small amount,
you can often get by, by turning the Transmitter knob to # 3.
6. For problems with large, heavy metal mailboxes, see page 4.
Other tips
1. The knob on the Transmitter is set on # 4 for curb side mailboxes. Do not
move the knob unless you have a wallmounted or slot type mailbox.
2. The Transmitter uses a ball tilt switch so it is normal for you to hear a
rattle when you tip it.
Limited Warranty
During first 30 days, defective units must be returned to retailer for an exchange.
After 30 days, call Hanna Products at 309-788-1982.
This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the
party responsible could void the user's authority to operate this equipment.
Patent No. 7,506,796
Designed in USA
Made in Taiwan
page 2
2
3
Set knob
1
on # 4
4
FCC ID: RNCMAIL-1200
Hanna Products Inc.
2602 37th Street, Rock Island, IL 61201
Email: hannaproducts@mchsi.com
Phone: 309-788-1982
page 3
Advertisement
