Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SOLDER PEAK ZD-8908
Summary of Contents for SOLDER PEAK ZD-8908
- Page 1 Hot Air SMD Rework Station Model: ZD-8908...
- Page 2 2. IMPORTANT SAFETY INFORMATION • When using electrical appliances basic safety precautions should always be followed. • Check that the voltage indicated on the rating plate corresponds with that of the local network before connecting the appliance to the mains power supply. •...
- Page 3 5. Operation • Connect the mains plug to a socket. • Assemble the nozzles into position. Note: Try to use nozzles with a larger diameter. • Turn on the power switch, set the air flow rate and temperature and put the unit on the racket. •...
- Page 4 6. The display and temperature setting 1. Press the button “+(UP)” or “-(DOWN)”to adjust the temperature. In short press, the set-point will change ±1℃ In long press, the set-point will change quickly and reach your target temperature. 2. “℃/ °F” is the transfer button between ℃/ °F The default unit is ℃, press the “℃/ °F ”...
- Page 5 * Preheat SMD Refer to the photo to preheat SMD. (Fig. I) * Soldering Heat the lead frame evenly. (Fig. II) * Washing When soldering is completed, please wash away the flux. Note: While you do soldering by Hot air, the defects such as solder balls, solder bridges might occur. We recommend you to examine the conditions of soldering sufficiently.
- Page 6 Caution-High Temperature Operation Do not use the SMD unit near ignitable gases, paper, or other inflammable materials. The nozzle air is extremely hot and can cause painful burns. Never touch the heater pipe or allow the heated air to blow against your skin. * Do not disassemble the product.
Need help?
Do you have a question about the ZD-8908 and is the answer not in the manual?
Questions and answers