Summary of Contents for PMDG McDonnell-Douglas MD-11
Page 1
Checklist + Flow-Procedure PMDG MD-11(F) DO NOT USE FOR FLIGHT McDonnell-Douglas MD-11(F) Checklist / Flow-Procedure including basic Flight-Planning-Charts for PMDG MD-11(F) with Microsoft Flight Simulator / Prepar3D created by Carsten Rau www.CarstenRau.de Version 7.0 Print Notice: Page size DIN A5. Print 2 pages per A4 or Letter page. This page is the front cover.
Page 2
PMDG MD-11(F) Attention: You should have read the PMDG MD11 introduction, especially where you find all 7 click spots if you operate in 2D-mode like me. I recommend setting the IRS alignment time to something like 180 seconds if you do not want to wait 10 minutes for the alignment.
Page 3
Checklist + Flow-Procedure PMDG MD-11(F) --- Check Ext Pwr Light Illuminated AC and DC 1, 2 and 3 Off Lights Extinguished Gen 1, 2 and 3 ARM Lights Illuminated BUS Off Lights (pwrd busses) Extinguished • Door(s) Open (via FMC Menu) •...
Page 4
Checklist + Flow-Procedure PMDG MD-11(F) --- Check APU PWR AVAIL Light Flashing till available, then … APU PWR AVAIL Light Illuminated steady AC / DC 1, 2, 3 OFF Lights Extinguished AC TIE 1, 2, 3 ARM Lights Illuminated GEN 1, 2, 3 ARM Lights...
Page 5
Checklist + Flow-Procedure PMDG MD-11(F) Weight Init Page ➔ PAGE Use UFOB Block-Fuel ➔ LSK R1 Enter ZFW (xxx.x) ➔ LSK R3 Enter ZFW-CG (xx.x) ➔ LSK R6 (easy auto-mode: 1st right click, then left click) Enter TO-CG (xx.x) ➔ LSK R5 (easy auto-mode: 1st right click, then left click) F-PLAN Page ➔...
Page 6
Checklist + Flow-Procedure PMDG MD-11(F) • Speed at flightplan Enter MACH • Departure Time Enter (UTC) • IFR Clearence Request --- Note Squawk, initial Alt, SID, etc. --- • Squawk • Voice Recorder Test Button Push & Hold 5 seconds --- You should hear a test tone &...
Page 7
Checklist + Flow-Procedure PMDG MD-11(F) • ANTI-ICE & DEFOG All extinguished --- Next step only if refueling (after turn-around) is planned. --- • FUEL USED RESET Button Push • FMA / Autopilot: IN / HP Set Barometer to IN or HP as...
Page 8
Checklist + Flow-Procedure PMDG MD-11(F) • Doors Slides Arm all (via FMC FS Shortcuts Menu) Engine s/u & Pushback: • Engine s/u & Pushback p/b clrc request • Beacon Light • AUX HYD PUMP 1 • ENG IGN A or B Push •...
Page 9
Checklist + Flow-Procedure PMDG MD-11(F) --- If FADEC Alternate Mode is displayed and not desired. --- • FADEC MODE Switches 1 - 3 Open, Push, Guard • Nose Light Taxi • Landing Light Ext Off • Logo Light • Pushback Finish •...
Page 10
Checklist + Flow-Procedure PMDG MD-11(F) Ready to Takeoff: • Parkingbreak • Thrust Levers Forward --- Move forward till „T/O Thrust“ is displayed on the PFD. --- • Parkingbreak Release --- Verify “T/O Clamp” indicated; following “T/O Thrust”. --- • Takeoff abortion impossible •...
Page 11
Checklist + Flow-Procedure PMDG MD-11(F) • Autobreak • FMA Altitude Readjust to next cleared / final Flight Level • Hand-off APP to CTR Change frequency • Anti-Ice (all) On (under 10°C OAT, see FMC PROG page) • Altimeter Readjust (above 18000ft) •...
Page 12
Checklist + Flow-Procedure PMDG MD-11(F) --- If magenta ADD DRAG message appears: --- • Speedbrakes / Spoiler Up (if required) • Altimeter Readjust (under 18000ft) • Hand-off CTR to APP Change frequency • Landing lights • Taxi light Land •...
Page 13
Checklist + Flow-Procedure PMDG MD-11(F) • Autopilot (FCP) Disengage (AP Disengage Btn) • Warnings • Brakes Disable auto-break • Runway Vacate („rwy vacated“) Final approach & Landing (w/o Autoland): • Flaps Lower as required till reaching 35° after “Gear Down”...
Page 15
Checklist + Flow-Procedure PMDG MD-11(F) Intentionally Blank PMDG MD11(F) Created by Carsten Rau (www.CarstenRau.de) Page 15...
Page 16
Checklist + Flow-Procedure PMDG MD-11(F) MD-11F --- Fuel Planning Charts: MD-11 see next page! * At MZFW the maximum range of 3500nm can only be achieved with additional reserves limited to 16.500 lbs (instead of 21.000 lbs), otherwise MTOW of 630.500 lbs will be exceeded.
Page 17
Checklist + Flow-Procedure PMDG MD-11(F) MD-11 --- Fuel Planning Charts: * At MZFW the maximum range of 3500nm can only be achieved with additional reserves limited to 11.500 lbs (instead of 21.000 lbs), otherwise MTOW of 630.500 lbs will be exceeded.
Page 18
Checklist + Flow-Procedure PMDG MD-11(F) ** At a payload of ≈ 100.000 lbs the maximum range of 6000nm can only be achieved with additional reserves limited to 10.000 lbs (instead of 21.000 lbs), otherwise MTOW of 630.500 lbs will be exceeded.
Need help?
Do you have a question about the McDonnell-Douglas MD-11 and is the answer not in the manual?
Questions and answers