POLTI DDV Protocol For Use

DDV - STEAM DISINFECTION DEVICE
COMPLIES WITH AFNOR NF T72-110 STANDARD
WARNING! THIS PROTOCOL DOES NOT REPLACE THE INSTRUCTIONS
AND WARNINGS CONTAINED IN THE USER MANUAL AND ON
THE APPLIANCE: PLEASE READ THEM BEFORE USE.
• Before starting the treatment, clean - if necessary - the surfaces and fabrics with the most appropriate method
for removing dirt and dust.
• If your appliance is equipped with steam adjustment - as it can also be used as a steam cleaner
- set it to an average level or, in the presence of preset programs, refer to the instruction manual.
• Heating the dispenser: when the appliance is first switched on, dispense "unusable" steam for about 30 seconds
downwards to reach the optimum operating temperature and pressure.
After each pause before treating surfaces or fabrics, dispense for a few seconds in the same way.

DYNAMIC STEAM DISINFECTION

Compliance with the
AFNOR NF T72-110 STANDARD

STATIC STEAM DISINFECTION

FREQUENT SANITISING ACTION

PROTOCOL FOR USE

HOW TO USE THIS APPLIANCE

CHOOSE THE OPERATION YOU WANT TO DO:
0.5 centimetres. Make at least one pass at
1
a speed of 10 centimetres per second.
distance of 10 centimetres (stand spacer)
The steam will be able to treat an area with
repeated strokes on the surface at about
Deliver steam, perpendicular to
the surface, maintaining a distance of
Deliver steam, perpendicular to
the surface, maintaining a maximum
for 30 consecutive seconds.
a diameter of approximately 10 cm.
Dispense steam with slow and
10 centimetres per second.
1