Table of Contents
Advertisement
Details
1 – On 12 volt panel, first switch on the Instruments switch (for network)
2 – Next switch on the GPS (chart plotter) switch
3 – The chart plotter should begin start up. It takes some time to boot. If nothing
happens, press the power button to turn it on. (We usually leave it on and then turn off
the switch at the 12 volt panel). At some point it asks you to press continue.
4 – The home screen displays icons (see photo) that you can press to choose any pre-
programmed page you want. The pages we have set up are Chart, Chart/Music, Radar,
Chart/Radar, Dual Chart, Dual Radar, Users Manual, and Data.
We respectfully ask that you not adjust the display settings, other than zooming in and
out. Please use the chart plotter only for position finding, not for setting way points.
Please do not adjust the current settings. (Sorry, but if we need to call a professional to
reset to defaults for the next guest, that will be on you.)
Last revised: April 2019
15
Advertisement
Table of Contents
