Reina ORNE Installation Manual

O RNE A N D R AN C E TOW E L RAI L
I NS TA LLATION G UIDE
Please read these instructions carefully before instalation and operation
1.This Towel Rail is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the Towel Rail by a person responsible for their safety.
2.In order to avoid a hazard, this Towel Rail must be installed so that the
bottom rail is at least 600mm above the floor.
3.This Towel Rail is intended to warm and dry towels and therefore is hot to
the touch.
4.The towel rail is to be installed so that switches and other controls cannot
be touched by a person in the bath or shower.
5.To avoid a hazard this towel rail must not be used to hold towels or any
other articles that have been in contact with oil, petroleum based products
or dry cleaning fluids.
6.Use this Towel Rail only with the voltage specified on the rating label.
7.Do not immerse in liquid or allow liquid to run into the interior of the
Towel Rail. Indoor use only.
8.Do not operate this towel rail if damaged or after the Towel Rail malfunc-
tions or has been dropped or damaged in any manner. Return to a qualified
electrical person for examination, electrical service or repair.
9.Use this Towel Rail only as described in this manual. Any other use is not
recommended by the manufacturer and may cause fire, electrical shock or
injury.
10. Do not use this Towel Rail in a window as rain may cause electric shock.
TOOLS REQUIED
Pencil
Hammer
Measuring Tape
Spirit level
Electric drill
Screw driver
ACCESSORIES
Wall anchors x4
Screws x4
Decorative cap x2
Mounting leg x2
Code Size
ORNE 760*580CM
RANCE 500*475CM
lease follow the below installation steps to complete the towel rail installa-
tion
Applided models
ORNE RANCE
Power Voltage
50W 220-240VAC,50HZ
40W 220-240VAC,50HZ