Phoenix 5145546 Manual

P1 ENGRAVING UNIT
Engraving Unit for the CMS-P1-PLOTTER
CLIPLINE
Data Sheet
103072_00_en

Description

The engraving unit has been specially developed for use on
the CMS-P1-PLOTTER.
It cannot be adapted for use with a different
X-Y unit.
Only CMS-P1-PLOTTERs with a
manufacturing date of January 2004 or later
can be used in conjunction with the engraving
unit. For the manufacturing date, refer to the
rating plate on the CMS-P1-PLOTTER.
PH X MM Y ZZZ (Y = year, MM = month)
Example: PH 0 07 6 001 = device
manufactured in July 2006
The engraving unit is designed for use on the CMS-P1-PLOTTER for the purpose of engraving plastic labels.
The use of other materials, such as aluminum, brass, steel, and glass is not permitted.
The use of lubricants and coolants is not permitted, as the vacuum cleaner used cannot handle liquid materials.
Only use Phoenix Contact gravers.
Make sure you always use the latest documentation.
It can be downloaded at www.download.phoenixcontact.com.
A conversion table is available on the Internet at
www.download.phoenixcontact.com/general/7000_en_00.pdf.
This data sheet is valid for all products listed on the following page:
© PHOENIX CONTACT - 10/2006
The engraving unit is designed for use on the
CMS-P1-PLOTTER for the purpose of engraving plastic
labels. Plastic sheets with pre-assembled labels are
available from Phoenix Contact.
For normal applications, we recommend the use of gravers
with a grinding angle of 15°. These are available in widths
of 0.2, 0.3, 0.4, 0.5, 0.7, and 1.0 mm.