MACGREGOR G6000T Instructions page 2

JR G6000T Set-up Addendum for Henesleit
3DNT and Rocket Owners
The Henesleit 3DNT and Rocket models incorporate a
very powerful tail rotor that uses a gear ratio and
mechanical pitch change ratio that is very different from
the majority of model helicopters on the market today.
This requires the gyro to have a different set-up to
achieve the maximum possible performance of these
two high quality combinations. Please adjust your gyro
and transmitter to the following settings where they
differ from the original instruction manual.
Please Note: Fine tuning may required. These values
are given as a guide only.
(Figures used with the kind permission of Russ Deakin. For a more
detailed review of the G6000T gyro in combination with a 3DNT please
read the October 2002 issue of Model Helicopter World)
Servo Horn Length : 14mm
Travel Adjust (ATV) : 74%
Exponential: 70%
Heading Hold: 50%
Tail Blade Length: 100mm