Craftmade TH045 Assembling Instructions

40
50
30
60
20
70
10 80
90
%
100
0
HUMIDITY
TH045 Clock Assembly Instructions
Ensemble de l'horloge TH045
El Reloj TH045
Parts Included:
Top/Bottom Poles
2 Ea.
Base Cover
Base Allen Wrench
1 Ea.
1 Ea.
1 Ea.
Assembly:
Time: 20-30 minutes
Tools Required: Adjustable Wrench, Allen Wrench (provided)
1. Base can be installed with stake for insertion into grass/soil surfaces, lag bolts for
cement surfaces or wood screws for deck installation. Thread foot tabs or stakes into the
four holes under base. If foot tabs are used, adjust height as necessary leveling fixture
for uneven surfaces. If stakes are used, find level, firm grass/soil area for inserting
stakes. If lag screws are used, insert lag screw and secure top portion onto base using
lock washer, washer and hex nut. If wood screws are used, screw firmly onto level wood
surface. Plug hole where screws were inserted with Hole Cover.
2. Attach bottom pole to the base. Slide base cover over bottom pole onto bottom base.
Place petal brake knuckle on bottom pole allowing it to slide down to the base. Attach top
pole to bottom pole. Pull the brake knuckle in place to cover the seams of the connected
poles and screw it into place using the provided Allen wrench and set screw.
3. Attach clock display head to top pole by inserting the top pole into the fixtures bottom
cup. Using allen wrench, turn embedded set screws at bottom of head clockwise until it
catches pole and head is secure.
Clock Adjustment:
To adjust the Clock, turn adjustment dial to adjust needle on the face of the unit.
Installing and Replacing AA Battery for Clock:
On back of clock, remove round plastic cap by pulling metal ring. Snap off the battery
cover located on the bottom of the clock's gear box.
Insert battery matching the "-" and "+" markings, as indicated on the inside of the
battery housing, to the markings located on the battery.
Replace battery cover by snapping cover into place, and re-attach round plastic cap.
NOTE: Do Not Mix Old and New Batteries.
TH045 Clock
Assembly Instructions
Wood Screw
3 Pc
Hex Nut
3 Pcs
Stake
1 Ea.
Washer
3 Pcs
40
30 50
60
20
70
Lock Washer 10 80
90
0 % 100
HUMIDITY
3 Pcs
Lag Bolt
Petal Brake
3 Pcs
Knuckle Decorative Head
1 Ea. 1 Ea.
E1
Washer
(3)