Clas Ohlson 30-7115 Quick Start Manual

Gas Torch
Art.no 30-7115
Please read the entire instruction manual before use and save it for future reference. We reserve the right for any errors in text or images and for
making any necessary technical changes to this document. If you should have any questions concerning technical problems please contact our
Customer Services.
Area of use
• Soldering
• Defrosting of pipes
• Removing paint and putty
• Repairs
• Warm-up
• Lighting a fire
Safety
Warning
Keep the gas torch out of children's reach.
Never store the gas torch in temperatures above + 50 °C and
do not expose it to direct sunlight for long periods of time.
The gas burner must only be used in well ventilated areas and
well away from flammable materials and liquids. Fire hazard!
• Do not use the gas burner to light cigarettes, cigars or pipes.
• Contains extremely highly flammable pressurised gas.
• Only use butane (intended for refilling cigarette lighters) when refilling.
• Avoid inhaling the fumes from soldering or from other applications.
Make sure the area is well ventilated.
• The flame of the gas torch is very hot and can burn you; protect
your hands and face. Bear in mind that the flame can be difficult
to see.
• Make sure that the gas torch is completely turned off and cold
before putting it away.
• Hold the gas torch upright, the flame could go out if the torch
is used in other positions.
• Allow the torch to cool completely before refuelling it.
• The gas torch must not be modified or disassembled.
• Do not puncture the gas canister or throw it onto the fire.
• Light the gas torch with the nozzle pointing away from your face
and hands. Bear in mind that in certain situations the butane flame
is barely visible.
fig. 1
GREAT BRITAIN
customer service tel: 0845 300 9799 e-mail: customerservice@clasohlson.co.uk
internet: www.clasohlson.com/uk
Setting of airflow
Cyclone torch
Flame
Normal flame
protection
Ignition button
Foot plate
(can be removed)
Use
Refilling gas
Use only butane gas. Make sure the installation knob for gas flow is on
OFF. Hold the gas torch upside down and put the gas container nozzle
straight in to the refill valve (fig. 1). Let the gas torch stand for at least
2 minutes for the gas to stabilise.
Ignition
Switch the safety latch to OFF mode and turn the settings knob
for gas flow anticlockwise 2/3 revolutions (fig. 2). The gas will hiss
out through the opening/nozzle protection. Press the button to light
the flame (fig. 3).
Setting the flame
Set the length of the flame using the knob for gasflow. Then set
the width by turning the knob for airflow, using your fingers.
Shut off/Safety latch
Turn the knob for gasflow clockwise as much as possible to put
the flame out, make sure the flame is completely out (fig. 4). Switch
the safety latch to LOCK mode after putting the flame out, for safety
reasons.
Disposal
Follow local ordinances when disposing of this product. If you are
unsure about how to dispose of this product contact your municipality.
fig. 2 fig. 3
Setting knob for
gas flow
Safety latch
Metal construction
Refill valve
fig. 4
fig. 4