Page 1
INSTRUCTION MANUAL DISPLAY COOLER Model No.: C-02RM Please read this manual carefully, and make sure to keep this manual in the place accessible by the user at any time MADE IN CHINA Warning ◆ This appliance can be used by children aged from 8 years...
◆ -- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. 1.Structural diagram The above picture only for reference, refer to the real product. 2.Specifications C-02RM Model name...
Page 3
Climatic Class Anti-shock pro- tection Class Storage Tempe- 0~10 rature (℃) Capacity (L) Rated Voltage AC110-120V/60Hz Input power Refrigerant R600a Vesicant C5H10 The above specifications are subject to improvements. 3. Safety Cautions 1.This unit uses AC220V-240V/50Hz or AC110V-120V/60Hz, there should be a 500va stabilizer if the voltage fluctuation exceed 198V- 264V/50Hz or 98V-127V/60Hz respectively.
Page 4
6.Keep away from explosive, hazardous goods such as ether, gas, alco- hol, bonding agents, gunpowder etc. 7.Keep away from spray of inflammables such as paints, coating mate- rials etc. 8.After the unit is switched off, it should not be restarted within 5 mi- nutes.
Page 5
2.Clean the unit before using. 3.Adjust the foot to make the unit steady according to the ground condition to lower the noise. 4. After moving the unit, place the unit for 30 minutes before switching it on. 5. Running: close the door and connect the power, turn on the light switch on the casing back.
3.Check if the knob is on an appropriate position before using, frequent adjustment is not appropriate when using. Normally in summer, the ambient temperature is high, anti clockwise turn the knob to “5”, while in winter, the ambient temperature is low, clockwise turn the knob to “1”.
1.Keep the door gasket clean, remove it from the door and wash it. Dry and seal it as before. Putting some talcum powder on the magnetic surface would prolong its service life. 2.Light replacement:remove the top cover, take out the light, replace with a new light, then mount it again..
1. Sometime hear light sound of water flowing in the unit, this is the sound of refrigerant flowing inside the pipe. 2. Compressor, condenser and the part of the unit near door is warm or too hot. 3. In a humidity place, there is dew on the casing or the door, it can dry by dry cloth.
Page 9
too long time and no is at fault (leakage or vice department for frost on the surface blocked) repair of the evaporator There is frost or ice on the walls of the inner cabinet and too Thermostat does not Ask service depart- low internal tempera- work ment for repair...
feet The fastener of the Fasten the loose unit is loose fastener Pipes are touching Careful separate the the compressor touched pipes The light is burned Light is not on Replace the light Warning: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
Page 11
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
Need help?
Do you have a question about the C-02RM and is the answer not in the manual?
Questions and answers