Advertisement
Usable and Non-usable Utensils
Induction Zone:
Usable pans and pots:
Steel, cast iron, enameled iron, stainless steel, flat-bottom pans / pots with bottom diameter
from 12cm to 26cm.
Magnetic
Iron pot
Iron board pan
Stainless steel
satainless
pot/kettle
steel pan
Non-usable pans and pots:
Ceramic Zone:
1) You can recognize good pots and pans by their bases. The base should be as thick and flat as possible.
2) When buying new pots and pans, pay particular attention to the diameter of the base. Manufactur-
ers often only state the diameter of the rim.
3) Pots with aluminum, or copper bases can cause metallic dis-colouring on the ceramic glass surface
which is very difficult or impossible to remove.
4) Be very careful when using cast iron pans or pots with damaged bases which are rough and or have
burrs on them. Scratches can occur if they are slid across the surface.
5) If you use special pots and pans( e.g., a pressure cooker, simmering pan, wok etc.), please observe
the manufacturer's instructions.
6) For safety reasons do not clean the appliance with a steam jet or high pressure cleaner.
Iron color pan
Magnetic iron
Iron fryer
enamel pan
6
1. Plug the power plug into the socket, a "Beep" sound is heard. All of the indicator lights will be flashed
for one time and then off. It means that the cooker is well connected with power.
2. Press the "On/off " key in the control area of the corresponding burner one time, the related display
shows "- -". It means that the cooker in under standby mode.
3. Power Setting:
★ Induction Zone:
● Press "+" or "-" key when the unit is on standby mode, the LED display will show "5" it means the
defaulted power level is 5. User can press "+" or "-" key to adjust the desired power level. There are
8 power levels in total from 1 to 8.
● Press "Boost" key once and the LED display will show "b", it means the unit is working at maximum
power 2800W.
Please see the details in the following sheet.
1
2
3
4
Power
600
800
1000
1100
NOTE: After cooking, press "On/Off" key to switch off the burner. The hot indicator will light up
if the glass plate is over 60℃ to remind that the cooking plate is too hot to touch.
★ Ceramic Zone：
● Press "+" or "-" key when the unit is on standby mode, the hot indicator will be lighted up and the
LED display will show "5" which means the power level is 5 with double rings.
● Press "Heat zone" key once, you can switch between inner ring and outer ring. The LED display
will show "8", means the unit is working at power level 8 under the inner ring mode.
● Press "Heat zone" key again, you can change to outer ring. The LED display will show "8", means
the unit is working at power level 8 under the outer ring mode.
● Press "Heat zone" key third time, you can switch back to double ring mode. The LED display will
show "5", means the unit is working at power level 5 under double rings mode.
5
6
7
8
b
1300
1400
1600
2000
2800
7
Advertisement
