Infotainment System - General Instructions For Use - Cupra BORN Owner's Manual

General instructions for use
Operating indications
The infotainment needs a few seconds for
●
the complete start-up of the system and
during that time it does not react to inputs.
Only the image of the rear view camera sys-
tem can be displayed during system start-up.
The display of all indications and the exe-
●
cution of functions only takes place once the
infotainment system has finished booting.
The duration of the system booting depends
on the number of infotainment functions
and may take longer than normal in the
event of very high or very low temperatures.
When using the infotainment system and
●
corresponding accessories, e.g., head-
phones, bear in mind country-specific regu-
lations and legal provisions.
The online navigation, online voice com-
●
mand and Internet Radio functions (among
others) require the activation of CUPRA
CONNECT Gen4 services (linked to the CU-
PRA CONNECT PLUS pack) and an Internet
connection for the vehicle. The data trans-
mission must not be limited to perform the
functions.
To use the infotainment system, simply
●
lightly press a button or touch the screen.
For the correct operation of the infotain-
●
ment system it is important that it is switched
Infotainment system
on and that, if necessary, the time and date
of the vehicle are set correctly.
If a function button is missing on the
●
screen, it is not a device defect, but corre-
sponds to the specific equipment of the
country or version.
Some infotainment functions can only be
●
selected when the vehicle is at a standstill. In
some countries, the gear selector must also
be in parking position P or neutral N. This is
not a malfunction, but is due to compliance
with legal requirements.
Restrictions on the use of devices using
●
Bluetooth® technology may apply in some
countries. For further information, contact
the local authorities.
If you disconnect the 12-volt battery, turn
●
on the ignition before restarting the infotain-
ment system.
If the setup is changed, this may change
●
the display on the screen and in some cases,
the infotainment system may behave in a
manner different to that described in this in-
struction manual.
When the drive system is switched off and
●
the charge level of the vehicle's 12 V battery
is low, the infotainment system switches off
automatically.
Ensure that any repairs or modifications
●
that need to be carried out on the infotain-
ment system are carried out by a specialised
workshop. To do so, CUPRA recommends
going to a specialised CUPRA dealer or any
SEAT dealership.
Using a mobile phone device inside the ve-
●
hicle may cause noise in the speakers.
On vehicles with park assist, the audio
●
source volume is automatically lowered
when reverse gear is selected. The volume
reduction can be adjusted.
Information about the included software
●
and the license conditions can be found in
Settings > Copyright.
When selling or lending the vehicle, make
●
sure that all saved data, files and settings
have been deleted and, if necessary, exter-
nal audio sources and data media have been
removed. Remember to also restore the fac-
tory settings to unlink your CUPRA ID user-
name from the vehicle, as well as your CU-
PRA CONNECT Gen4 pack.
Note
You will find more information and tips for
using the infotainment system in the Help
menu.
HOME screen
In the control and display unit you can set up
the views and representation on the home
screen or use the factory setting templates.
»
213