Page 1
IDU (Indoor Unit) Tune up procedure Installation IDU can be placed on the supporting structure like a desk or installed on the interior wall. If choose to install on the wall, fallow instruction below. Then connect cables from each of TX, RX patch antennas to IDU as described in this manual. Please note that all the procedure must take while power is off.
Page 2
1.2 Grounding After GIR-2005 Indoor Unit is fixed to the wall, using 14 Square Cable put the ground post of GIR-2005 chassis to the earth where has good conductivity. Refer to the figure below. Fig. 3-2 GIR-2005 Grounding 1.3 Connecting Internal antenna with cables Place GIR –...
Page 3
. ODU (Outdoor Unit) Tune up procedure Installation Place ODU outside of building with no visible obstacle in front of ODU. Follow the instruction below to install ODU on the proper place, install external antenna, and connect cables between antenna and ODU as well. Refer to the figure 3-3 below.
Page 4
it, and assemble ODU to the pipe using a wall and pipe bracket. 4×M7 Anchor Bolt 4×(2×M4 Bolt) Fig 3-4 Outdoor Unit Fixing to the wall 2.2 Grounding After GIR-2005 Outdoor Unit is fixed, should ground it using 14 Square Cable connected to the grounding post of GIR-2005 chassis and earth where has good connectivity.