Advertisement
2. INTRODUCTION
High output lighting with even spread of light. Low power consumption saving money on energy costs. Manufactured to Low Voltage Directive
72/73/EEc. supplied with 5mtr cable and Bs approved plug. Ideal for the professional garage/workshop user.
Specification:
Model No: ..........................................................................ML13230V.V2
Voltage: ............................................................................................230V
Power: .............................................................................................. 11W
Cable Length: .................................................................................. 5mtr
Fitted Plug: ........................................................................................ Yes
Overall Length: ........................................................................... 410mm
3. OPERATION INSTRUCTIONS
3.1
to use the lamp, plug the transformer plug into the mains socket to turn the light on.
3.2
When finished, disconnect the transformer plug from the mains supply, fold the lamp and store it in a safe, dry and childproof location.
4. MAINTENANCE
WARNING! Be sure to disconnect the lamp from the power supply before carrying out any maintenance.
4.1
GENERAL MAINTENANCE
4.1.1
Keep the lamp clean.
4.1.2
check cable for any signs of wear. If the cable is worn/broken, remove the lamp from service immediately and have it repaired by a
qualified electrician.
4.2
REPLACING NEON TUBE (Refer to fig.1 & fig.2)
NOTE: Use only Sealey replacement neon tubes, Part No: ML1112CB.
4.2.1
Disconnect from the power supply.
4.2.2
remove end cap from the outer plastic tube.
4.2.3
squeeze the outer plastic tube at the area of the lugs on the tube retaining clip, allowing the clip to clamp the top of the
tube. Grip the inside of the clip with a pair of long nose pliers (not supplied) and extract the clip and tube.
NOTE: Use caution when handling a tube and dispose of in accordance with local authority guidelines.
4.2.4
Attach the tube retaining clip to the top of the replacement tube.
4.2.5
Place the replacement tube into the outer plastic tube and locate the fittings with the socket in the lamp base.
4.2.6
firmly press the tube into the lamp base ensuring that the tube retaining clip is correctly located within the outer plastic tube.
4.2.7
re-fit the end cap.
fig.1
Parts support is available for this product. to obtain a listing and/or diagram, please log on to: www.sealey.co.uk,
Environmental Protection.
recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack sealey Limited
email: sales@sealey.co.uk or phone: 01284 757500
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park,
Bury st. Edmunds, suffolk,
IP32 7Ar
Original Language Version
fig.2
WEEE Regulations.
Dispose of this product at the end of its working life in compliance
with the Eu Directive on Waste Electrical and Electronic Equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. contact your local solid waste
authority for recycling information.
01284 757500
01284 703534
www.sealey.co.uk
W e b
sales@sealey.co.uk
email
ML13230V.V2
Issue: 1 - 04/07/13
Advertisement
