Double din touch screen tft monitor dvd player (10 pages)
Summary of Contents for Soundstream VRN-75HB
Page 1
VRN-75HB In-Dash 7” Monitor Touch Screen Built-in GPS /CD/MP3/MP4 AM/FM Radio With Bluetooth VRN-75HB OPEN/TILT Owner’s Manual Take the time to read through this owner’s manual. Familiarity with installation and operation procedures will help you obtain the best Performance from your new GPS/DVD-receiver.
WARNING! To promote safety, certain functions are disabled unless the parking brake is on. The Unit is designed to detect parked status and must be connected to the power supply side of the parking brake switch. Improper connection or use of his connection may violate applicable law and may result in serious injury or damage.
INSTALLATION / UN-INSTALLATION Note Before starting installation of the unit, make sure the wiring is connected properly. Use only the parts provided with the unit to ensure proper installation. The use of unauthorized parts may cause malfunction. Install the unit where it does not get in the driver’s way and will not injure the passenger in case there is a sudden stop, like an emergency stop.
WIRING CONNECTIONS NOTE: Never connect cable to the system while it is connected to the battery power. Whenever the unit is disconnected from the battery, the preset memory will be erased and the unit will go back to its factory defaults. Note: To watch video the parking wire should be connected to break signal.
Page 7
Connecting the reversing line to taillight on the car Reverse driving light Car frame Pink wire Rear view video camera lead Battery Car frame Gearbox After connecting, when you start up the reverse gear, the unit will receive the picture from car rear view camera.
PANEL VRN-75HB OPEN/TILT 1. Touch panel 2. Release button Press to detach and release the front panel. When the unit was released, it will switch off automatically after a few second. Detach/Attach the Panel: Press REL button and pull out the left side to detach the panel.
Page 9
4. GPS button Press it to enter GPS mode. 5. MENU button Press it to back to home page. 6. BAND In Radio mode, press it to change radio band in sequence of FM1 → FM2 → FM3 → AM1 → AM2.
19. Anti-Theft LED flash 20. Connector 21. GPS MAP CARD 22. Reset button Default to factory setting。 REMOTE CONTROL 1.POWER Press it to turn on or turn off the unit. 2. MODE button Press it to select the mode: Radio, DISC (if there is a disc in unit), USB (if there is a USB device in the unit), CARD (if there is a SD/MMC card in the unit) and AV IN.
Page 11
In Radio mode, press to change radio band in sequence of FM1 → FM2 → FM3 → AM1 → In DVD mode, press it to play randomly. 6. Cursor buttons Use the buttons to select the menu item. The title it track or to show next frame. 7.
23. SEL button (Only for RDS) Press it to enter the SOUND SETTING menu, and press Cursor UP/DN buttons to choose an item and press cursor left/right buttons to set the item. Press SEL button again to exit the menu. / seek + button In DVD mode, Press button to skip to the next track.
MAIN MENU The best way to discover the program is to explore each screen in detail, and to find out how to move from one to another. Read this chapter for a guided tour. Unit starts by displaying the Main menu. This is the root of the screen hierarchy, and you can simply access all features by tapping on the touch screen buttons.
◆DVD PLAYER To start DVD Player, tap DVD icon from main menu screen. TOUCH SCREEN MENU In DVD mode touch it return to DVD menu. In VCD mode touch it can choose PBC ON or OFF. Touch it to skip to the previous track. Touch it to pause/play.
Press it to repeat REP 1 => REP DIR => REP ALL. Touch it to turn on / off random playback. Press it to select file. Press it to select title (only the file has many files). Press it to repeat REP CH => REP TT => REP ALL. Touch this button adjust the EQ, it can choose User =>Rock =>Pop=>...
Page 16
Time & Date Wallpaper Tap Time & Date setting button to setup time and date. Tap Wallpaper button to setup wallpaper Radio Area Radio Area: tap it can choose radio area such as USA, China, Europe, Russia, Australia, Middle East and Japan. About Tap SWC item to program Steering Wheel Control Just show you the firmware version...
GPS SCETION To start GPS mode, please insert SD card in GPS slot on the front panel. Firstly tap GPS ico on Main Menu to enter to GPS Menu ; Secondl y tap Setting icon and touch Navi path to choose Map;...
Page 18
BULETOOTH SCETION Warning: Driving and having a Telephone conversation at the same time is dangerous, please park your car before having a telephone conversation. The supplier waves any and all liability when this warning is not followed. To enter Bluetooth mode, you can tap Bluetooth icon on Main menu or long press the mute/Bluetooth button on the Remote Control or press mode button on remote or on front panel.
1. Dial BUTTON Tap on Dial button to enter call mode. In Call mode, the unit can be used as your phone. Making and receiving calls are possible with BLUETOOTH. Simply tap phone number and tap button to make a call, and tap button to hang up.
OTHER FUNCTIONS Subwoofer Connect the subwoofer to the unit using sub output (see electrical diagram). Tap it on screen enter into main menu setting choose EQ, or touch this icon directly enter to EQ mode set subwoofer ON to enable subwoofer. Parking When the car is stopped and the parking brake is working, the screen can display the video image, otherwise the screen can't display the video image...
MAP Instruction To start GPS mode, please insert SD card in GPS slot on the front panel. Choose Navigation path and touch the Enter icon to enter the GPS (Navi path choose only for first using). You can choose road and run GPS. Navigation setup -\Storage card\iGO When using the navigation software for the first...
Page 22
After the initial setup, and whenever the software is started, the Navigation menu appears. You have the following options: to select your destination by entering an address or selecting a place of interest, a location on the map or one of your Favorite destinations.
Page 23
In the Navigation menu, tap then In the Navigation menu . The . In the US, the screen proposes only the Destination menu provides you with the following options: country while in other countries you can see the city or town where you are located to specify an address as your destination If needed, change the country or the state.
Page 24
5. Quick Find Enter the street name: With the help of Quick Find, you can search for a location near to a known Place of Interest. Search Use the keyboard to enter a part for the Place by its name first and then find your of the street name.
Page 25
6. Navigating to a place of interest to search around the current position or if it is not available, around the last know position to search for a place within a selected city or town. to search for a place around the destination of the active route to search along the active route, and not around a given point.
Page 26
At the top of the screen, you see your heading and the house numbers on left and right if you have The list of place categories appears. Tap not selected a route destination. When navigating slide your finger to browse the list, and tap a route, you see the next maneuver and the next street/road on your route.
Page 27
Change the function buttons in the Quick menu of the Map screen. Access the clothing size converter Select the type of vehicle you are driving, the road types used in rou te pl a nni ng , an d th e route Access the fuel consumption monitor.
NOTES ON DISC Only use groundless loudspeakers. Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your loud speakers at higher volumes. Use 4~8 Ω (Ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit. Do not use 3-cable loudspeakers and do not connect the loudspeakers minus to the car body.
TROUBLESHOOTING Cause Symptom Remedy Replace with fuse of the same amperage. If Fuse is blown the fuse blows again, consult your store of GeneralPower does not purchase turn on.(No sound is produced.) Consult your local retailer. In correct wiring 1. Turn off the unit. 2.
Page 30
TROUBLESHOOTING Symptom Cause Remedy IF THE POWER SUPPLY IS PROPERLY CONNECTED THE CAR IGNITION IS NOT TO THE CARACCESSORY SWITCH THE IGNITION NO POWER KEY TO “ACC”. THE FUSE IS BLOWN. REPLACE THE FUSE. REMOVE THE DISC IN THE PLAYER THEN PUT A DISC CANNOT BE LOADED.
TECHNICAL SPECIFICATIONS General Power supply: 11~16V DC Current consumption: Max. 10 A Maximum power output: 75W x 4 channels (max) DVD/SVCD/VCD/HDCD/MP3/MP4/VIDEO/CDDA/Picture Compatible formats: CDCD-R/-RW/DVD±R/±RW playback Dimensions (W x D x H) / 178*170*50 mm/2 kg weight: Working temperature -10℃ - +60℃ range: ESP function: 10 sec.
Need help?
Do you have a question about the VRN-75HB and is the answer not in the manual?
Questions and answers