Advertisement
TECHNICAL NOTE
How to use the RENATRON Reprocessing Connector
The Reprocessing Connector is a barrier connector that isolates a
dialyzer from the RENATRON
System. A unique quick disconnect feature allows for fast and easy
connections.
To use the Reprocessing Connector a RENACLEAR must have the
modified header cleaner assemblies that attach to the Reprocessing
Connector. A RENATRON Reprocessing System must first be calibrated
for use with the Reprocessing Connector. This is accomplished by
performing a calibration test using the Reprocessing Connector.
Recalibrate the RENATRON if necessary following the RENATRON
Directions for Use.
1. The Reprocessing Connectors should
be disinfected with either 1% RENALIN
solution or full strength ACTRIL
for 30 minutes before use.
2. The Reprocessing Connector should first be
attached to the dialyzer blood port connectors.
RENACLEAR Modified
Header Cleaner
Assembly
3. The dialyzer can now be attached to the
RENACLEAR Header Cleaner Assembly or the
Colder Connectors on the arterial inlet and
venous outlet lines of a RENATRON.
RENATRON Colder
Connector
or RENCLEAR
Dialyzer Header Cleaning
®
®
®
solution
®
0
15
30
Advertisement
Table of Contents
Summary of Contents for Medivators RENATRON
- Page 1 To use the Reprocessing Connector a RENACLEAR must have the modified header cleaner assemblies that attach to the Reprocessing Connector. A RENATRON Reprocessing System must first be calibrated for use with the Reprocessing Connector. This is accomplished by performing a calibration test using the Reprocessing Connector.
- Page 2 Reprocessing Connectors attached to the dialyzer. CLICK After the dialyzer is removed from the RENACLEAR, it can be attached directly to a RENATRON. 6. After the dialyzer has been reprocessed remove the Reprocessing Connector from the dialyzer and clean off any obvious blood materials.
Need help?
Do you have a question about the RENATRON and is the answer not in the manual?
Questions and answers