Advertisement
Compliance with KDB996369 D03 OEM Manual
1. List of applicable FCC rules
WiFi 2412-2462MHz FCC Part 15.247 Max output power 15.92dBm
WiFi 5180-5240MHz; 5745-5825MHz FCC Part 15.407 Max output power 13.65dBm
2. Summarize the specific operational use conditions
When use this modular transmitter, please do not change the antenna and antenna
gain, the power setting and country code can not be changed.
The Antenna type is monopole antenna and 2T2R
2400-2483.5MHz Peak Gain: ANT A: 2.55dBi; ANT B: 0.94dBi;
U-NII-1 Band (5150-5250MHz) Peak Gain: ANT A: 1.90dBi; ANT B: 0.8dBi;
U-NII-3 Band (5725-5850MHz) Peak Gain: ANT A: -0.04dBi; ANT B: -3.17dBi.
3. Limited module procedure
Not applicable
4. Trace Antenna designs
Not applicable
5. RF exposure considerations
This modular transmitter should be used in the mobile conditions and 20cm from a
person's body, the host product manufacture should be put those information in the
end-product manual to the end users. If RF exposure statement and use conditions
are not provided, then the host product manufacture is required to take responsibility
of the module through a change in FCC ID(new application)
6. Antenna
The Antenna type is Planar antenna and 2T2R.
2400-2483.5MHz Peak Gain: ANT A: 2.55dBi; ANT B: 0.94dBi;
U-NII-1 Band (5150-5250MHz) Peak Gain: ANT A: 1.90dBi; ANT B: 0.8dBi;
U-NII-3 Band (5725-5850MHz) Peak Gain: ANT A: -0.04dBi; ANT B: -3.17dBi.
7. Label and compliance information
We Had put the FCCID: 2AU3BU9W34 on the modular transmitter and put the
compliance information in this modular use manual, the host device manufacture
need to provide a physical or e-label stating" contains FCCID: 2AU3BU9W34" with
their finished product and the compliance information should be attached in the
end-product manual.
8. Information on test modes and additional testing requirement
When this modular transmitter installed in a host product, then can use a 4 pin-USB
extend cable, the 4 pin port connect with the modular and USB port connect with a
test computer which installed the test software "MP tool" then can use the software
control the modular working at test mode, select the transmit mode, channel and
power setting.
Advertisement
