Maintenance - Qlima SRE0031TC Operating Manual

L

MAINTENANCE

Switch off the heater and let it cool down, before you start any maintenance work. Also disconnect the plug
from the mains. Your heater needs hardly any maintenance.
Clean the ventilator filter (Fig R).
Clean the fuel filter:
1. Remove the removable tank 4 from the heater and remove the fuel filter (Fig. S). Some drops may leak
from the filter; keep a cloth at hand.
2. Remove the dirt by tapping the fuel filter upside-down against a hard surface. (Never clean it
with water!)
3. Reinstall the fuel filter into the heater.
We recommend that you remove dust and stains from time to time with a damp cloth, because otherwise these
may cause stains that are hard to remove.
G
Do not use solvents or alcohol to clean the heater: fire hazard. Clean very dirty components with a
light synthetic cleaning agent.
G
Do not remove any heater components yourself. Always contact your dealer for repairs.
G
When the power cord is damaged, it may only be replaced by an authorised fitter. Use a new cord of
the type H05 VV-F.
M
STORAGE (END OF THE HEATING SEASON)
At the end of the heating season, you must store the heater in a dust-free place, if possible in its original
packaging. Unused fuel cannot be used in the next heating season. We therefore recommend that you burn
up all fuel. If there is still some fuel left, do not throw it away, but dispose of it in accordance with the local
regulations for the disposal of domestic chemical waste.
Always start the new heating season with fresh fuel. When you start re-using the heater follow the instructions
again (starting from section A and as specified).
N
TRANSPORTATION
Take the following measures to avoid fuel leakage during the transportation of the heater:
1. Let the heater cool down.
2. Remove the removable tank 4 from the heater and remove the fuel filter. Some drops may leak from the
filter; keep a cloth at hand. Store the fuel filter and the removable tank outside the heater.
3. Empty the fixed fuel tank (fig. U).
4. Place the transport cap.
5. Always move the heater in an upright position.
Make the fixed tank empty with a fuel pump before transportation or in case of wrong or dirty fuel. First
remove the fuel filter and then insert the fuel pump into the empty fixed tank. Follow the same procedure if
the fuel tank contains water.
4
30