Installation And Use - AllPondSolutions PLED-310 Manual

INSTALLATION & USE
Important – ensure the unit is disconnected from the mains electricity supply
whilst it is installed.
Before installing your light fixture, measure the width of your tank and
ensure it meets the min / max tank width in the specifications below.
Screw 2 metal rods into each of the brackets as tightly as possible.
For the smallest tank size suitable for your light fixture, you will need to
position the brackets on your tank rim with the screw on the inside of the
tank (image 1). For larger tanks, position the brackets with the screw on
the outside of the tank rim (image 2).
Feed the two metal rods into the two circular holes in the side of your
light fixture. Repeat with the other rods into the other side of the unit.
Extend the two brackets so the width between the two brackets
matches the width of your tank.
Carefully transfer the light fixture onto your tank – ensure the unit is
carried HORIZONTALLY to prevent the metal rods from sliding out of the
unit. Carry the unit with your hands between the rods and fingers under
the light on both sides (image 3) to ensure the full unit is secure. Be
careful to ensure the power cord does not come into contact with the
water.
Once the brackets are positioned on your tank rim, tighten the white
screws on the brackets to fix to your tank.
Ensure the light fixture is mounted correctly and securely positioned on
the aquarium before operating the appliance.
Connect transformer to your mains electricity and switch the red button
to the ON position.