1. Manuals
  2. Brands
  3. Conairphone Manuals
  4. Answering Machine
  5. TAD2018
  6. Owner's manual

Conairphone TAD2018 Owner's Manual

Callkeeper digital answering system
Hide thumbs
Table of Contents

Advertisement

Quick Links

Reduce 74.3% printed.
IB Size is 105 x 138 mm.(IB-4579)
OWNER'S MANUAL
ON/OFF
GREETING
VOLUME
CallKeeper
Digital

Answering System

Model TAD2018
R
PLAY
REPEAT
STOP/SAVE
R
R

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TAD2018 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Conairphone TAD2018

Summary of Contents for Conairphone TAD2018

  • Page 1: Answering System

    Reduce 74.3% printed. IB Size is 105 x 138 mm.(IB-4579) OWNER'S MANUAL PLAY ON/OFF REPEAT GREETING STOP/SAVE VOLUME CallKeeper Digital Answering System Model TAD2018...

  • Page 2: Location Of Controls

    Location of Controls TOP VIEW & SIDE VIEW : Microphone Message/Batt.Low Indicator On/Off Greeting REAR VIEW: AC Adaptor Jack Play PLAY Repeat ON/OFF REPEAT Stop/Save GREETING STOP/SAVE VOLUME Volume Control Ring Select Telephone TS 4 Extension Line RING SELECT AC9V 200mA TS 4 TEL LINE USE ONLY WITH CLASS...

  • Page 3: Important Safety Instructions

    Important Safety Instructions BEFORE USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALW AYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY, TO PERSONS, INCLUDING THE FOLLOW ING: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3.

  • Page 4: Safety Instructions For Batteries

    Safety Instructions for Batteries CAUTION TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS, READ AND FOLLOW THESE INSTRUCTIONS. 1. Use only the size and type of batteries mentioned in the Owner's Manual. 2. Do not dispose of the batteries in a fire. The cells may explode. Check with local codes for possible special disposal instructions.

  • Page 5: Installation

    TAD2018 near an AC power outlet and a wall telephone jack (RJ11C). Desk or Table Installation 1. If you are connecting your TAD2018 to an extension telephone, plug one end of the extension telephone line cord to the extension line jack (located on back of unit).
  • Page 6 Installation (Cont.) Figure B Optional viewing angles (see base diagram for viewing position) MESSAGE Indications Message Indicator Status Reason Message Indicator counts down from Unit is checking memory. 9 to 0. Message Indicator displays "9" You have 9 or more messages. messages.
  • Page 7 Recording Your Greeting (Cont.) To record your own personalized outgoing greeting: 1. Press and hold down the GREETING button. 2. After you hear one beep tone, speak clearly towards the built in microphone. You have a maximum of 30 seconds to record your GREETING.

  • Page 8: Message Playback

    YOU FOLLOW THE SAVE PROCEDURE. To Stop Message Playback During message playback, press and release the STOP/SAVE button. Your TAD2018 will reset and will save all messages. To Repeat the Current Message During playback, press and quickly release the REPEAT button ONCE.

  • Page 9: Special Features

    10th ring , pause 10 seconds, and then automatically disconnect the telephone line. Voice Activated Recording (VOX) Your TAD2018 records messages for up to 45 seconds, as long as the caller speaks. To avoid unnecessary pauses due to hang-...

  • Page 10: Remote Operation

    Remote Message Playback 1. Call your unit from a touch-tone telephone. 2. After your TAD2018 answers, it plays the outgoing greeting and beeps once. Dial your three digit security code within 10 seconds after the beep, pressing and holding each digit for 1-2 seconds.

  • Page 11: Troubleshooting Guide

    Remote Operation (Cont.) To Retrieve Messages When Recording Memory Is Full 1. When the message capacity is full, the unit will announce 3 short beep tones after answering the phone. 2. Within 10 seconds after, dial your 3 digit security code. 3.
  • Page 12 PROBLEM POSSIBLE CAUSE No answer AC adaptor is disconnected from wall outlet or back of unit Power to electrical outlet may be off Telephone line is not connected to wall jack No incoming Unit is in the "OFF" mode messages recorded AC adaptor is disconnected from wall outlet or back of...
  • Page 13 PROBLEM POSSIBLE CAUSE No remote Unit is in the "OFF" position operation AC adaptor is disconnected from wall outlet or back of unit Power to electrical outlet may be off Calling from a phone that is not outputting tone dialing (rotary, PABX, cellular).

  • Page 14: Fcc Wants You To Know

    FCC Wants You to Know This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a Product in the format US:DJTAN00BTAD2018. If requested, this number must be provided to the Telephone company.
  • Page 15 FCC Wants You to Know An applicable certification jacks Universal Service Order Codes (USOC) for the equipment is provided (i.e., RJ11C) in the packaging with each piece of approved terminal equipment. A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA.

  • Page 16: Limited Warranty

    Limited Warranty CONAIRPHONE Consumer Hotline If you have any questing concerning your Answering System, call our Consumer Hotline at 1-800-366-0937, 8:30 am - 9:00 pm (EST), Saturday 8:30 am - 12:30 pm (EST) orvisit us on the Web at www.conairphone.com.

Table of Contents