Conairphone SW2514 Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS
Before using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury to
persons including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall telephone jack and power outlet before
cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp
cloth for cleaning.
4. Do not use this product near water, for example, near a bath tub, wash
bowl, kitchen sink, or laundry tub, in a wet basement or near a swimming
pool.
5. Do not place this product on an unstable cart, stand, or table. The
product may fall causing serious damage to the product.
6. Slots and openings in the cabinet and the back and bottom are provided
for ventilation, to protect it from overheating. These openings should
never be blocked by placing the product on the bed, or other similar
surface. This product should not be placed near or over a radiator or heat
register.
7. This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of power
supply to your home, consult your dealer or local power company.
8. Do not allow anything to rest on the power cord. Do not locate this
product where the cord will be abused by persons walking on it. Do not
attach the power cord to building surfaces.
9. Do not overload wall outlets and extension cords as this can result in the
risk of fire or electric shock.
10.Never push objects of any kind into this product through cabinet slots as
they may touch dangerous voltage points or short out parts that could
result in the risk of fire or electric shock. Never spill liquid of any kind on
the product.
11. To reduce the risk of electric shock, do not disassemble this product, but
take it to a qualified serviceman when some service or repair work is
required. Opening or removing covers may expose you to dangerous
voltages or other risks. Incorrect reassembly can cause electric shock
when the appliance is subsequently used.
12.Unplug this product from the wall outlet and after servicing to qualified
service personnel under the following conditions:
a. When the power supply cord or plug is damaged or frayed.
b. If liquid has been spilled into the product.
c. If the product has been exposed normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions because improper adjustment of other controls
may result in damage and will often require extensive work by a
qualified technician to restore the product to normal operation.
e. If the product has been dropped or cabinet has been damaged.
f. If the product exhibits a distinct change in performance.
13.Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lightning.
1
14.Do not use the telephone to report a gas leak in the vicinity of the leak.
SAVE THESE INSTRUCTIONS

SAFETY INSTRUCTIONS FOR BATTERIES

CAUTION
TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS, READ AND
FOLLOW THESE INSTRUCTIONS.
1. Use only 4 x 1.5v AAA size alkaline batteries.
2. Do not dispose of the batteries in a fire. The cells may explode. Check
with local codes for possible special disposal instructions.
3. Do not open or mutilate the batteries. Released electrolyte is corrosive
and may cause damage to the eyes or skin. It may be toxic if swallowed.
4. Exercise care in handling batteries in order not to short the batteries with
conduction materials such as rings, bracelets, and keys. The batteries or
conductors may overheat and cause burns.
5. Do not attempt to recharge the batteries identified for use with this
product. The batteries may leak corrosive electrolyte or explode.
6. Do not attempt to rejuvenate the batteries identified for use with this
product by heating them. Sudden release of the battery electrolyte may
occur causing burns or irritation to eyes or skin.
7. When replacing batteries, all batteries should be replaced at the same
time. Mixing fresh and discharged batteries could increase internal cell
pressure and rupture the discharged batteries.
8. When inserting batteries into this product, the proper polarity or direction
must be observed. Reverse insertion of the batteries can cause charging
and that may result in leakage or explosion.
9. Remove the batteries from this product if the product will not be used for
a long period of time (several months or more) since during this time the
batteries could leak in the product.
10.Discard "dead" batteries as soon as possible since "dead" batteries are
more likely to leak in a product.
11. Do not store this product, in high-temperature areas. Batteries that are
stored in a freezer or refrigerator for the purpose of extending shelf life
should be protected from condensation during storage and defrosting.
Batteries should be stabilized at room temperature prior to use after
cold storage.
2