Technical Data; Included In Delivery; General Safety Notes - Faust VS 180-01 Operating Instructions Manual

Anleitung VS 180-01 08082000 24.10.2001 13:37 Uhr
GB
USE
The orbital sander is designed for the
sanding of wood, metal, plastic and
similar materials when using the cor-
rect sanding paper.

Technical data

Voltage 230 Volts
Power consumption 150 Watts
Grinding surface area 188 x 90
Sandpaper size 238 x 90
Vibrations per minute 20,000
Sound pressure level LPA 87 dB(A)
Sound power level LWA 92 dB(A)
Vibration a w 8,4 m/s 2
Weight 1,4 kg
Totally insulated

Included in delivery

VS 180-01,
Dust extraction connectors ø 32, ø 36,
3 sheets of sandpaper

General safety notes

– Always remove the plug from the
power supply socket before carrying
out any maintenance or repair work
such as cleaning the sander or
changing the sandpaper!
– Always disconnect the machine by
removing the plug from the socket,
not by pulling on the mains cable.
– Always wear safety goggles and
dust mask when working.
– Keep the workplace clean and well
illuminated.
– Ensure that the workpiece is suffi-
ciently secured so that you are able
to work safety and effectively.
– Keep children away from the
machine.
– Always keep your machine clean,
and check for possible defects of
damage after every job.
– Always ensure that the switch is
switched off before you insert the
plug into the power supply socket.
– Ensure that any platforms you are
working on are sturdy and stable.
– If the machine is damaged, use the
exploded diagram and the spare
parts list to determine the precise
cause of the damage, and order any
neccessary parts from Customer
Service.
4
Seite 4
1 Front gripp
2 Machine identification
plate
3 On/Off trigger
4 Locking button
5 Main grip
6 Vibration plate
7 Clamping device
8 Vacuum cleaner
attachment
9 Electrical cord
Fitting the dust bag
Important!
It is imperative to use the dust bag for
health reasons.
Warning!
– The pad sander is not designed
for wet sanding.
– When using a cable reel, make
B
sure to roll up the cable comple-
A
tely (wire diameter min.
1,5 mm 2 ).
– Disconnect the sander from the
power supply when work has
been completed.
– If the machine is defective, have
it serviced by a qualified dealer
immediately.
ON/OFF switch
Switching on: Press in switch A
Continuous duty: Secure switch A with
lock button B
Switching off: Press in switch A
briefly