Advertisement
Assembling the SDR Cube Transceiver
Home Bill of Materials
RXAMP
X-LPF
RF Functional Test
The purpose of this section is to test the SDR Cube with the RF Front End (e.g., with the Softrock RXTX 6.3: SR-Base, TXPA, RXAMP
and X-LPF modules).
Step 1:
The Starting Point ...
Here's what you should be starting with, as a result of going through
Or, if you didn't intend on using the main Cube Enclosure, here are some views of the completed and connected boards out in the
open ...
http://www.sdr-cube.com/construction/rf-test.html
SDR Cube Transceiver
Online Assembly Guide
Detailed construction notes for building and testing each of the SDR
I/O Board
Controls Board
Internal Cable Set
External Cable Set
Digital Subassembly Test
Final Assembly
... (Section version 1.0a)
Cube kit modules
DSP Board
Softrock SR-Base
Main Enclosure
Accessory Enclosure
RF Functional Test
Final Assembly
...
Page 1 of 3
Softrock TX/PA
1/20/2011
Advertisement
Table of Contents
Summary of Contents for Midnight Design Solutions SDR Cube
- Page 1 RF Functional Test RF Functional Test ... (Section version 1.0a) The purpose of this section is to test the SDR Cube with the RF Front End (e.g., with the Softrock RXTX 6.3: SR-Base, TXPA, RXAMP and X-LPF modules). Step 1: The Starting Point ...
- Page 2 Assembling the SDR Cube Transceiver Page 2 of 3 Step 2: Apply power ... With the Softrock front end installed, the typical current draw from a 12V supply will be about 280 ma (In transmit this will increase to about 350 ma.)
- Page 3 Assembling the SDR Cube Transceiver Page 3 of 3 Copyright 2010 Midnight Design Solutions, LLC. All Rights Reserved. Page last updated: Jan 9, 2011 http://www.sdr-cube.com/construction/rf-test.html 1/20/2011...
Need help?
Do you have a question about the SDR Cube and is the answer not in the manual?
Questions and answers