Advertisement
INSTALLATION
INSTALLATION SHOULD BE CARRIED OUT BY SERVICE PERSONNEL ONLY, IN LINE WITH
LOCAL WIRING REGULATIONS. ENSURE POWER IS ISOLATED FROM THE
CONNECTION POINT BEFORE STARTING THE INSTALLATION PROCESS.
The mains cable can either enter from behind the dryer for discreet installation
(Requires a sunken mains cable) or from below for simple installation (Does not
require a sunken mains cable.)
To install DV2100...
1. Remove the dyer front guard by first unscrewing the three retaining screws
holding the guard in position, using the supplied hex key.
2. Offer the hand dyer backplate up to the mounting surface and mark the four
fixing points through the holes in the backplate.
3. Drill the four marked fixing holes and insert the supplied wall plugs.
4. Offer the dryer backplate up to the wall, and insert the four fixing screws through
the backplate into the wall plugs.
5. Connect the three wires coming from the mains supply to the terminal block,
ensuring the correct locations are used for each wire as described below.
WIRING MARKINGS
Terminal Block Marking
L (Live)
N (Neutral)
(Earth)
5. Replace the front guard and loosely insert the three retaining screws, before
tightening them all to fix the guard in position.
6. Use an appropriate silicone sealant and culkling gun to apply a silicone seal
around the entire dryer, between the front guard and mounting surface. This will
both further secure the front guard in place and protect from water ingress.
USING DV2100
DV2100 incorporates no touch sensor activation for hygienic use. Before inserting
hands under the dryer, shake off excess water. The dryer will stop activation when
hands are removed.
SPECIFICATION
Unit
DV2100P
Voltage
230V ~ 50Hz
Dimensions(mm) 252 x 273 x 207
Weight
2.5 Kg
Power Draw
2,100 w
Motor Speed
5,000 RPM
Drying Time
25 seconds
Noise Level
75 db
R3 07/14
Sterling House
Grimbald Crag Close
Knaresborough
North Yorkshire
HG5 8PJ
Standard wire colour
Brown
Blue
Green & yellow
Unit
DV2100W
Voltage
230V ~ 50Hz
Dimensions(mm) 252 x 273 x 207
Weight
3.2 Kg
Power Draw
2,100 w
Motor Speed
5,000 RPM
Drying Time
25 seconds
Noise Level
75 db
T +44 (0)800 988 5359
F +44 (0)1423 863 497
W www.pandlsystems.com
E info@pandlsystems.com
UK
Unit
DV2100S
Voltage
230V ~ 50Hz
Dimensions(mm) 252 x 273 x 207
Weight
2.9 Kg
Power Draw
2,100 w
Motor Speed
5,000 RPM
Drying Time
25 seconds
Noise Level
75 db
Information provided on these instructions is modified and
updated from time to time.
redevelopment of our products. As such, it is not intended that
you should rely on it or that it should form part of any contract.
P+L Systems Ltd
1
2
WEEE Compliance No. WEE/GF0661QR
This is due to the constant
2014
C
Advertisement
