Advertisement
Quick Links
Advertisement
Summary of Contents for Option Technologies OptionFinder K4
- Page 1 OptionFinder ® Hardware Guide www.optiontechnologies.com 407-872-3333...
-
Page 2: About This Guide
6. The system is designed to operate in an area with a maximum range of 150 x 150 feet. 7. The OptionFinder K4 system is a wireless radio system that works in the 2.4GHz range. The base stations may be set to 80 different channels within this range. - Page 3 1. Connect one end of the RJ-45 cable to your computer and the other end to the base station. 2. Connect the power cord to the base station. Plug the cord into a power outlet. Figure 1 – OptionFinder K Series Full Size Base Station Option Technologies International, LLC, © 2019, All Rights Reserved 8402-102518...
- Page 4 Position the base station away from other electronic devices, i.e. projectors, speakers, • computers, etc. If you are using multiple base stations, place the base stations at least 3 feet apart. • Option Technologies International, LLC, © 2019, All Rights Reserved 8402-102518...
- Page 5 OptionPower it will Fail because it is searching for the default base station and not your specific hardware. Click Yes on the message to remove the default base definition and search again. Option Technologies International, LLC, © 2019, All Rights Reserved 8402-102518...
- Page 6 If the base station is connected directly to your computer then you must define an alternate IP address or, if that isn't available, set your computer to a specific IP address. Option Technologies International, LLC, © 2019, All Rights Reserved 8402-102518...
- Page 7 7. Click the Alternate Configuration tab and then click User Configured 8. Enter an IP address, i.e. 10.1.1.1 9. Enter 255.255.255.0 as the subnet mask. 10. Click OK 11. Click OK again Option Technologies International, LLC, © 2019, All Rights Reserved 8402-102518...
- Page 8 9. Click Advanced Hardware Configuration 10. Remove existing the existing base station 11. Click Add New Base 12. Enter a number for the base station (i.e. the base ID number referenced above) Option Technologies International, LLC, © 2019, All Rights Reserved 8402-102518...
-
Page 9: Programming Keypads
7. Press and hold the Send key on the keypad and click the Set Keypad ID button 8. Repeat steps seven for all remaining keypads and then click Stop Programming Option Technologies International, LLC, © 2019, All Rights Reserved 8402-102518... - Page 10 5. The base Channel is listed on the lower portion of the dialog, select a new Channel and click Change Channel 6. Click OK to save your changes and close the dialog box Option Technologies International, LLC, © 2019, All Rights Reserved 8402-102518...