Page 1
Storno CQM6113 Rev. A This manual refers to version 6114-3.8a of the program for the STORNO CQM6000 radio for use between 136-174 MHz, written by StrayCat. Black text is adapted for PI4GN 11-2016...
Storno forum with lots of info. About the software The set basically works on a 12.5 KHz grid. The program has two arrays of channels in ROM, 100 channels each and numbered 00-99. Switching between channel arrays is performed by clicking the key "Mode selector"...
Page 3
The scan sub-mode: The scan sub-mode is entered/left by pressing the S key and is working in modes 0 and 3. The scan sub-mode has its own indicator - LED "Scanning indicator". In the scan sub-mode, the keys "Volume up" and "Volume down" are used to increase/decrease the number of the current channel (mode 0) or frequency (mode 3).
Page 4
Is the number of the string. 12345 Is a string with the ID number of your radio. The string is selected by successive pressing the Bell key. In total there are 9 strings, and you can change the ID numbers by typing a new ID number from the keyboard. Is the flag.
Page 5
Control box keys from left to right and up and their functions: On/Off On/off key for the transceiver. Press for three seconds for a total reset of the software. Then turn set on again. Speaker On/off key for the audio amplifier Volume down In usual mode to decrease the audio.
Page 6
Entering/ending ‘simplex mode’. The display will show the channel number, the frequency and the channel spacing: 12.5, 25 or 50 KHz. (12.5 KHz is 12 on the display!) In this mode you can directly set a frequency using Queue, scan by hand using Volume down and Volume up or use automatic scan in frequency interval using A.
Page 7
Instellingen Leg de set op de kop, verwijder het zwarte deksel en vervolgens de blikken afscherming. Deze blikken afscherming is niet altijd aanwezig. De foto is genomen met het front naar je toe. Vermogen Het HF vermogen is instelbaar tussen 5 en 20 watt. Bij een instelling op ca. 10 watt trekt de set ca.
Page 8
Frequenties in ROM versie 1.1 PI4GN In bank 1 ( / ): In bank 2 ( Alle marifoonkanalen. Alle 16 repeater kanalen RX/TX, genummerd Ze zijn geplaatst conform de officiële 00-15. nummering, dus 00-40 (inclusief 29 en 30) en Verder: 60-99.
Page 9
Aansluitingen: Aan de achterzijde van de mobilofoon bevindt zich een 25 polige (computer) stekker (female). Onderstaand de aansluitingen op deze connector: J901 Type Function Rear Battery +12V 1,2,14 Power Battery Ground 12,13,25 Loudspeaker + Speaker Loudspeaker - Tx Key PTT sense Microphone Mic Hi Mic/ptt/aux/sense Common Signal Ground...
Page 10
Aansluitbox: Er zijn diverse types in omloop:...
Page 11
Aansluitingen via de aansluitbox: Alternatieve (low budget) aansluiting: Het is ook mogelijk om voeding, luidspreker en microfoon direct op de 25 polige connector aan te sluiten. De diode D1 is niet nodig als je maar 1 microfoon gebruikt. De mobilofoon is intern gezekerd.
Page 13
Microfoon: Het model MC6001 heeft een ingebouwde versterker en werkt op voeding vanuit de set. In de set wordt de voeding via een weerstand aangeboden. Over die weerstand wordt de signaalspanning afgenomen. Drukschakelaar S2, indien aanwezig, wordt niet gebruikt. Houder & sleutel: Om de set los te nemen uit de houder steek je de sleutel in het sleutelgat rechtsonder in...
Page 14
Reset automatische uitval na 10 uur: Na 10 bedrijfsuren krijgt de set vanuit de microprocessor een “uit bevel”. Dit zit in de Firmware en is niet eenvoudig te wijzigen. Zeker bij gebruik als Winlink transceiver is dit erg vervelend. Rinus, PA2MDL, maakte een simpel schakelingetje: ...
Need help?
Do you have a question about the CQM6113 and is the answer not in the manual?
Questions and answers