Advertisement
Available languages
Available languages
Top plitncht integrttion
You have to make a cut of 745 x 745 mm minimum.
Retliizttion of the ailiicone joint tround the plitncht
(!) Warning: it is very important to follow this procedural step in order so as to ensure a perfect seal between
the worktop and the plancha.
The frame of the plancha, by construction,
is raised by 3 to 5mm
You need to make a joint about 0.5cm
thick and fill inside the stainless steel
frame.
Use the NOVASIL silicone cartridge
S-805 supplied with your product, the en-
tire product must be applied.
1.
Fill the space between the plancha
frame and the worktop.
2.
Create a tight joint on the work sur-
face to prevent infiltration.
3.
Leave the joint to dry for 24 hours
without heating the plancha.
4.
Warm up the plancha gradually in
steps.
20
Advertisement
