Advertisement
2.
INTRODUCTION & SPECIFICATION
Quickly and easily cuts windscreen bonding. Safety throttle prevents inadvertant starting and
features integral regulator for speed control. Exhaust is ducted away from work and operator. A
range of optional blades is available increasing the versatility of the knife in garage and workshop.
Supplied with offset straight blade and hex key.
Blade frequency . . . . . . . . . . . . . 367Hz
Blade size. . . . . . . . . . . . . . . . . . 57mm
Air consumption . . . . . . . . . . . 10.6cfm
Operating pressure. . . . . . . . . . . . 90psi
Weight . . . . . . . . . . . . . . . . . . . . 1.4kg
Inlet. . . . . . . . . . . . . . . . . . . . . . 1/4"BSP
3.
PREPARING TOOL FOR USE
3.1.
Air Supply
Recommended hook-up procedure is shown in fig 1.
3.1.1. Ensure tool air valve (or trigger) is in "Off" position before connecting to the air supply.
3.1.2. You will require an air pressure of 90psi, and an air flow according to specification.
3.1.3. WARNING! Ensure the air supply is clean and does not exceed 90psi while operating the
tool. Too high an air pressure and unclean air will shorten the product life due to
excessive wear, and may be dangerous causing damage and/or personal injury.
3.1.4. Drain the air tank daily. Water in the air line will damage the tool.
3.1.5. Clean air inlet filter weekly.
3.1.6. Line pressure should be increased to compensate for unusually long air hoses (over 8
metres). The minimum hose diameter should be 1/4" I.D. and fittings must have the same
inside dimensions.
3.1.7. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain
that all connections are secure.
3.2.
Couplings.
Vibration may cause failure if a quick change coupling is connected directly to the tool.
To overcome this, connect a leader hose to the tool. A quick change coupling may
then be used to connect the leader hose to the air line recoil hose. See fig 1 & 2.
fig 1
4.
OPERATING INSTRUCTIONS
4.1.
FITTING A BLADE
WARNING! Disconnect from the air supply before changing blades.
4.1.1. Use hex key to remove retaining screw (Item 9B on parts diagram) and retaining spacer (9A).
4.1.2. Place the blade onto the spindle.
4.1.3. Replace the spacer and screw and secure with hex key, but do not over tighten.
Check that replacement blade is not damaged, (cracks, deformations etc).
Also check the mounting washer to ensure it is not deformed, burred or notched.
Original Language Version
fig 2
WK025
Issue: 2 - 11/11/09
Advertisement
