Advertisement
Quick Links
Advertisement
Summary of Contents for Waters Andew Alliance OneLab+
- Page 1 INSTALLATION GUIDE OneLab standalone server Copyright © 2020 Andrew Alliance S.A.
-
Page 2: Safety Instructions
Safety instructions • The device must always be completely switched off (cables removed) before moving it. • The user must maintain a distance of at least 20cm from the product (WiFi antenna) while it is being installed and operated. • The device is intended for indoor use only. •... -
Page 3: What's In The Package
What’s in the package OneLab standalone server Power supply USB WiFi Adapter (UP Squared system) (only for Service & Support use) Product overview USB 3.0 USB 3.0 OTG HDMI USB 3.0 2x DC-IN Gigabit Ethernet 2x DisplayPort Wi-Fi antenna connectors... - Page 4 A. Installation of the standalone server Unbox the Screw the 2 antennas standalone in the back. server. Plug the standalone server into a power source. The server should become ready in less than a minute. You will know that the OneLab Standalone Server is ready when you will see the “onelab_standalone”...
- Page 5 B. Access to OneLab Connect your compute to OneLab standalone WiFi network a. Go to your Wi-Fi settings and select the network named “onelab_standalone” b. Enter network password “OneLab_Standalone” Launch a web browser, type http://192.168.5.1 and log into OneLab using the credentials Work email: onelab@andrewalliance.com Password:...
- Page 6 Annex 1: Pairing your connected device with OneLab In case you need to pair the device (e.g. switch from Wi-Fi to Ethernet): Press 5 times the main button Wait the LED sign to turn blue and blink After a couple of minutes, the de- vice will inform you when it is in installation mode.
- Page 7 In case of Wi-Fi connection, select the onelab_standalone wireless network. Network password: OneLab_Standalone If wired connection will be used, simply follow the instructions stated in the pairing application. At this step, fill the form with these information then continue the installation. Web address: http://192.168.5.1 Work email:...
- Page 8 Annex 2: Power OFF the OneLab server Never remove the server from the power before switching it off. Use the tip of a pen to press the reset button for 5 seconds and wait until the LED will turn OFF. Then, you may unplug the device from the power.