Frequently Asked Questions; Care And Maintenance - Pure Fun 9335MSS Product Manual

FREQUENTLY ASKED QUESTIONS

Question: "How should I clean my
swings and seesaw?"
Answer: you should clean the
product with a solution of warm
water and Non- Corrosive/Abrasive
soap. Dampen a rag with this
solution and wipe completely dry
before using.
CARE & MAINTENANCE
• Before each use of this product, inspect the entire assembly
and replace any worn, defective or missing parts.
• The following conditions could represent potential hazards:
Missing, improperly positioned, or insecurely attached seats;
A bent or broken frame; Cracked or broken seats. Cease
using seesaw immediately and secure it against unauthorized
use if any of these conditions are present.
• Regularly check to see if the steel tubes, seats, backrests and
other parts are tightened and completely secure. Replace
worn & damaged parts if found and if necessary, secure from
use until replacement parts can be obtained.
• If the paint is chipped, we recommend you lightly rub the
damaged area and cover using a non-toxic enamel paint.
As a way of saying thank you for purchasing one of our products, here is a 10% OFF coupon for
MODEL#9335MSS
Question: "A seat seems loose,
what should I do?"
Answer: Make sure the Bolts/Nuts
under the plastic seat are secure.
Cleaning your Playground Equipment
Thank You Coupon!
your next purchase at
www.PureFun.net
Use Code: GQBRANDS10 at Checkout
Question: "Something was missing
from the packaging," "I need to
purchase a replacement part" or "I
discovered a damaged piece. What
should I do?"
Answer: Contact customer service.
You must have proof of purchase
and/or order confirmation available to
be considered for warranty
replacement. You must report
missing pieces within 30 days of
purchase.
• High touch surfaces made of plastic or metal, such as grab
bars and railings should be cleaned routinely.
• Do NOT use bleach as it may cause colors to fade.
• Use wet towel or cloth with mild soap and water solution to
wipe down metal parts, seats and handlebar. Dry
Immediately and do not allow children to use until
completely dry.
• To disinfect surfaces - use a 70% / 30% Rubbing Alcohol
to Water mix to clean seat and handlebar surfaces. The
surface must remain visibly wet for at least 4 minutes,
allowing it to dry on its own. After 4 minutes, the surface
may be rinsed thoroughly and wiped dry to eliminate water
marks. This solution will lose its effectiveness in about 24
hours, so a new batch must be made each day.
13