Advertisement
The definition of the rotary switch (TPD-283U-H):
No Mode
0
1
2
9
4
First Use of the TPD 2.8"H Series
GND
VDC (+12~+48V)
External Power
2. Supply power to the TPD-283-H/283U-H, wait for several seconds and
then you can see the default program run on it.
3. Try to touch on the icons on the bottom-right corner of the screen of
the TPD-283-H/283U-H and you can find that TPD-283-H/283U-H
switches to the setting pages.
TPD-283-H/283U-H Quick Start, version 1.0
Copyright © 2017 ICP DAS Co., Ltd.
Description
This is a special run mode which is used in the
Run & Update
development stage. The TouchPAD device can be
(Ethernet)
updated by a PC from the remote side through
Ethernet.
Ethernet
While the application run on the TouchPAD device
Force Update
seriously crashes, use this mode to update a new
application to the TouchPAD device through Ethernet.
Run Only
Run the program.
USB Force
Update a new application to the TouchPAD device
Update
through USB.
1. Connect wires as the figure or prepare an Ethernet cable
which will be used to supply power through PoE if there's a
RJ-45 Ethernet port on it. And set the rotary switch to zero
(At this point, the power is not yet supplied).
PoE Switch
Use a flat-head screwdriver to set
rotary switch
Last Revised: April 2017
All Rights Reserved.
- 3 -
E-mail: service@icpdas.com
Advertisement
