ADCO Millennium One Step Product Information

Millennium One Step™
Battery Powered Applicator
Description
Millennium One Step™ Battery Powered Applicator is specially
designed to be used with the Millennium One Step™
family of adhesives and sealants. The unique carriage design is
extremely durable and allows the user to install adhesive in an
upright position eliminating back strain. The tool is powered by
a 14.4 volt rechargeable battery. The motor is designed to run
on lower amps than conventional cordless tools which extends
overall battery life and reduces charging time.
User Instructions
1. Assemble carriage handle using the provided (4) screws
and lock nuts with the wrench and allen key (also
included).
2. Open the clutch lever to allow movement of the racks.
Retract the rack by pulling the rack handle away from the
tool.
3. Prepare adhesive cartridge by removing caps or plugs
and installing static mixing nozzle. Note: Follow
adhesive manufacturers complete instructions for
cartridge preparation.
4. Insert cartridge into the carriage. Line up the cartridge
and the cartridge nozzle opening for correct positioning.
5. Push the rack handle forward, lining up pistons with
the openings on the cartridge. Close the clutch lever to
engage clutch.
6. Slide the battery onto the handle until it is fully engaged.
7. Adjust speed control knob to desired flow. High speed is
designated on the knob by the largest "bubble" symbol.
Slower speeds; smaller bubbles. Note: Most applications
will require the tool to be operated at full speed.
8. Hold trigger to begin dispensing adhesive. Note: Trigger
must be depressed 2 times before tool operates when it
has sat idle. This is a power saving feature built into the
tool.
9. When finished dispensing, or when end of cartridge is
reached, release trigger, open clutch, then retract rack.
Remove cartridge.
CAUTION: All statements and technical information in this document are based on tests or data that ADCO believes is reliable.
However, ADCO does not warrant or guarantee the accuracy or completeness of this information. The user has sole knowledge and
control of factors that can aff ect the performance of ADCO's products in the user's intended application. It is the user's
responsibility to conduct tests to determine the compatibility of ADCO's product with the design, structure, and materials of the
user's end product and the suitability of ADCO's product for the user's method of application and intended use. The user assumes
all risk and liability arising out of such use.
P.O. Box 457, 4401 Page Avenue Michigan Center, MI 49254 Phone: (800) 248-4010 Fax: (517) 764-6697 www.adcocorp.com
Product Information
Features
Battery powered
Quick and easy use
Trigger delay
Durable construction
Strong motor
Packaging
Millennium One Step™ Battery Powered Applicator:
Description
Battery Powered
The One Step™ Battery Powered Applicator includes 2 re-
chargeable NiCd batteries, 1 battery charger, and 1 detach-
able carriage handle.
Safety
Protective equipment such as safety glasses and protective
gloves must be worn when operating or servicing the
Millennium One Step™ Battery Powered Applicator.
The Millennium One Step™ Battery Powered Applicator
should never be pointed at or near people. The applicator
should never be actuated when the outlet tip of the
adhesive cartridge is blocked or restricted by cured
adhesive, any object, or some part of the body.
Prior to working with this or any product consult product
label and Material Safety Data Sheet (MSDS) for necessary
health and safety precautions.
Benefi ts
Portable, no cords or hoses
Saves time and labor
Saves battery charge
Withstands everyday use
Can dispense higher viscosity
adhesives
Part #
EQ-7075-2KIT