Advertisement
Table of Contents
MOD-5184
KING BED
Thank you for purchasing the MODWAY KING BED！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 45 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
Component:
2
1
Headboard
3
Side Rail
5
Single Slat
7
Center Rail
Customer Service 908-368-1025︱www.modwayfurniture.com
3
4
5
4
7
7
8
8
8
8
8
x1
x2
x8
x2
Hardware:
A
B
C
D
E
F
G
H
6
4
5
4
5
8
3
8
8
2
Footboard
4
Double Slat
6
Low Post
8
Support Leg
Short Bolt M6x20mm
Medium Bolt M6x35mm
Long Bolt M6x50mm
Nut M6
Flat Washer
Rubber Insert
x16
Allen Wrench
Open Wrench
1
6
x1
x4
x2
x8
Page 1 of 3
x28
x8
x8
x16
x4
x1
x1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Midway MOD-5184
- Page 1 MOD-5184 KING BED Thank you for purchasing the MODWAY KING BED！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
- Page 2 MOD-5184 KING BED STEP 1: Insert Low Post (6) into Headboard (1) as shown. Attach by using Flat Washer (E) and Bolt (A) from the holes on the back of Low Post (6) and Headboard (1). Use Allen Wrench (G) to tighten Bolts (A) clockwise until secure.
- Page 3 MOD-5184 KING BED STEP 3: Place Center Rail (7) and 4 pieces of Support Leg (8) under assembled Double Slat (4) and Single Slat (5) as shown. Insert 4 pieces of Long Bolt (C) into the holes right on Center Rail(7) to connect it with Support Legs (8) as shown.
Need help?
Do you have a question about the MOD-5184 and is the answer not in the manual?
Questions and answers