Clover CCM630 Installation

INSTALLTION
1. Attach the Mounting bracket to the wall or
ceiling, wherever you want to install the camera.
Locate a wall stud or ceiling joist and secure
the bracket, using the supplied screws.
2. Install the camera to the Mounting bracket
and firmly tighten the swivel.
3. Connect the AC adapter to the DC
jack of the camera and into the 120V
AC outlet.(optional)
If the system does not function Properly, check the following points
TROUBLES
NO power (no picture / sound)
Picture flickering
Normal sound, dim picture
Picture too bright, too dark
Picture rolls and jumps
Scrambled picture
Picture smaller than screen
or volume weak
HOW TO OBTAIN FACTORY SERVICE
1. Original purchaser must fill out a warranty card and mail to Clover
Electronics USA with model number, serial number and date of purchase.
2. Please pack unit carefully and safely, and sent it prepaid and insured parcel
post to 1307 East 166th Street, Cerritos, CA 90703.
Please include a note stating how the unit is defective.
3. If the unit is returned within the warranty period, include a
proof of purchase and check for $15.00 to cover the cost of return
postage and handling. If the unit is out of warranty, please include a check for
$15.00 to cover the cost of return postage and handing. An estimate of the repair
cost will be sent for your approval.
4.Clover will repair or replace and return to owner all units under this limited
warranty.
LIMITED 2 YEAR WAEEANTY
This warranty gives the original purchaser specific legal rights and you may
have other rights which vary from state to state.
If Clover products do not function because of any defect in material or parts
workmanship. Clover will repair free for a period of 2 years on parts & labor
from the date of original purchase. This warranty does not cover incidental
or consequential damages unless the state of owner's residence specifically
prohibits limitations on incidental or consequential damages.

TROUBLE SHOOTING

before contacting the service center
CAUSE & REMEDIES
AC adaptor not plugged in.
Check the DC,audio, video cables
between the Camera and Monitor
Strong spotlight in the field of view
Improper brightness control on;
-
Setting on your TV/ Monitor
-
Lighting source in the field of view
Improper Vertical hold control setting
on your TV/monitor
House current may be too low
Bracket
Screw
Camera
Swivel
AC Adapter