Advertisement
CARE & MAINTANENCE
Care & Maintenance
Cover Installation & Removal
Each single driving light comes with 2* protective covers, 1x clear spot beam cover and
1x fluted flood beam cover. (*except for the VBP model which comes with 1x clear spot
cover).
To fit a protective cover, align the 5 x clips on the cover with the openings in the front of
the light, then push cover firmly until all of the clips 'click' into the openings. To remove the
cover, pull out on the 2 x lower tabs until the clips release from the light.
Clips
Tabs
Light Care and Maintenance
•
The light is not serviceable – DO NOT disassemble.
•
Clean lights using pH neutral soapy water and a soft nonabrasive brush or sponge. Rinse
thoroughly after cleaning.
•
DO NOT use solvents, Alkaline based cleaners or abrasive materials to clean the light.
•
If lights are exposed to a high salt environment or any other corrosive substance,
remove the light and mounting bracket from the vehicle and thoroughly clean and
rinse the components as outlined above.
•
Remove the clear cover and plastic cover on the rear of the light periodically to clean
any dirt and grime build up.
•
Regularly check all fasteners to ensure they are secured and properly torqued.
25
Night Hawk Variable Series Driving Lights
Openings
Warranty Policy
1.
Our Warranty
We warrant to you that the Kingsley product is free from defects in workmanship and
materials for the warranty period.
2.
Fitting and use
Please ensure you:
a. fit the Kingsley product in accordance with the product information and all
relevant vehicle safety and compliance laws
b. use the Kingsley product for the purpose for which it was originally designed and
in accordance with the product information and all relevant vehicle safety and
compliance laws
3.
Exclusions
Our warranty doesn't cover:
a. normal wear and tear
b. fitting the Kingsley product other than in accordance with the product
information and any relevant vehicle safety and compliance laws, including
incorrect fitting
c. using the Kingsley product other than for the purpose for which it was originally
designed or other than in accordance with the product information and any
relevant vehicle safety and compliance laws, including unusual, improper or
negligent use or misuse or overloading
d. misuse or neglect of the Kingsley product, including improper repair or
maintenance or failing to repair or maintain
e. alteration, abuse, acts of nature, terrorism, vandalism, collision, road hazards or
adverse conditions
4.
Making a claim
Please immediately contact us as soon as you become aware of a possible defect
in the Kingsley product. We'll arrange for you to either attend a Kingsley outlet (at
your cost) for a Kingsley representative to inspect the Kingsley product (as fitted to
your vehicle) or for you to return the Kingsley product to us. We'll also request you
to provide the purchase receipt and complete a warranty claim form. In order to
ensure our warranty is not voided, please keep the purchase receipt as proof of
purchase and don't remove the fitted Kingsley product from your vehicle before
contacting us. Note: Non-transferable warranty. The original purchaser can only
claim warranty. If your claim's in order, we'll notify you and (at our sole discretion)
either repair or replace the defective workmanship or materials (at our cost) or
refund to you the purchase price you paid for the defective Kingsley product. If
further information or investigation is required or if the claim does not meet the
requirements under our warranty, we'll let you know.
5.
Australian Consumer Law
The Kingsley product comes with guarantees that can't be excluded under the
Australian Customer Law. You're entitled to a replacement or refund if there's
a major failure and compensation for any other reasonably foreseeable loss or
damage. You're also entitled to have the Kingsley product repaired or replaced if it
fails to be of acceptable quality and the failure doesn't amount to a major failure.
Night Hawk Variable Series Driving Lights
WARRANTY POLICY
26
Advertisement
