Download Print this page

Sealey POWER TOOLS SA92.V2 Instructions page 2

Air tyre buffing kit

Advertisement

3.
PREPARING BUFFING KIT FOR USE
3.1.
Air Supply
3 .1 .1 . Ensure buffer air valve (or trigger) is in the "off" position before connecting to the air supply .
3 .1 .2 . You will require an air pressure of 90psi, and an air flow according to specification .
3 .1 .3 .  WARNING! Ensure the air supply is clean and does not exceed 90 psi while operating the
buffer . Too high an air pressure and unclean air will shorten the product life due to excessive
wear, and may be dangerous causing damage and/or personal injury .
3 .1 .4 . Drain the air tank daily . Water in the air line will damage the buffing kit .
3 .1 .5 . Clean air inlet filter weekly . Recommended hook-up procedure is shown in fig 1 .
3 .1 .6 . Line pressure should be increased to compensate for unusually long air hoses (over 8
metres) . The minimum hose diameter should be 1/4" I .D . and fittings must have the same
inside dimensions .
3 .1 .7 . Keep hose away from heat, oil and sharp edges . Check hose for wear, and make certain that
all connections are secure .
3.2. Couplings.
Vibration may cause failure if a quick change coupling is connected directly to the buffing kit . To
overcome this, connect a leader hose to the buffing kit . A quick change coupling may then be used
to connect the leader hose to the air line recoil hose . See fig 1 & 2 .
fig 1
4. OPERATING INSTRUCTIONS
WARNING! Ensure you read, understand and apply safety instructions before use.
Note: Numbers shown in brackets refer to item numbers in the parts list .
 WARNING! Disconnect from air supply before changing accessories or servicing .
4 .1 .
The buffing wheel (34) attaches directly to the arbor (28) and should be tightened using the
wrench (33) .
4 .2 .
To use the grinding stones (39) screw the 10mm drill chuck (35) onto the arbor (28) . Insert
the required grinding stone into the chuck and secure using the chuck key provided .
Remember to remove the chuck key .
4 .3 .
Depress the trigger to operate the buffing kit .
Original Language Version
fig 2
SA92 .V2
Issue: 2 - 13/11/09

Advertisement

loading

This manual is also suitable for:

Power tools sa92