Technical Specifications English; Introduction; Placing The Tool In Service - Hamach HD 98 User Manual

Technical specifications
Type HD 98
6 - 8 bar
Air pressure
ca. 300 l/min.
Air consumption
12.000
Speed
950 gram
Weigth
Sound level 78,0 dB(A)
Vibrationslevel 4,59 m/s
Sanding diameter 5 mm
150 mm
Sandingpad

Introduction

The HD 98, HDL 98 (5 mm sanding diameter) and the HD 983 (2,4 mm sanding diameter) is a one-
hand (HDL 98 –two hand) sander designed to prepare metal and wood surfaces for painting and
finishing operations. The HD 75 is a 75 mm spot repair tool (2,4 orbit) and a spot repair polishing tool.
All these tools are equipped with a dust extraction connection.
EMM is not responsible for customer modification of tools for applications on which EMM was not
consulted.
Warning
Important safety information enclosed.
•
Read this manual before operating tool.
•
• It is the responsibility of the employer to place the information in this manual into the hands of
the operator.
•
Failure to observe the following warnings could result in injury.

Placing the tool in service

Always operate, inspect and maintain this tool in accordance with all regulations (local, state,
•
federal and country), that may apply to hand held / hand operated pneumatic tools.
• For safety, top performance, and maximum durability of parts, operate this tool at 6,2 bar /
620 kPa maximum air pressure at the inlet with 8mm (5/16") inside diameter air supply hose.
Always turn off the air supply hose before installing, removing or adjusting any accessory on
•
this tool, or before performing any maintenance on this tool.
Do not use damaged, frayed or deteriorated air hoses and fittings.
•
Be sure all hoses and fittings are the correct size and are tightly secured. See drawing 1. For a
•
typical piping arrangement.
• During mounting the air nipple (¼ external thread with Teflon tape) hold the female
connector with a fitting wrench. This prevents shifting the internal connection.
Always use clean, dry air at 6,2 bar / 620 kPa maximum air pressure. Dust corrosive fumes
•
and/or excessive moisture can ruin the motor of an air tool
• Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet fuel.
•
Do not remove any labels. Replace any damaged label.
HD983
6 - 8 bar
ca. 300 l/min.
12.000
950 gram
78,0 dB(A)
2 4,59 m/s 2
2,4 mm
150 mm
6
HD 75 HDL 98
6 - 8 bar 6 - 8 bar
ca. 300 l/min. ca. 300 l/min.
12.000 12.000
950 gram 950 gram
78,0 dB(A) 78,0 dB(A)
4,59 m/s 2 4,59 m/s
2,4 mm 5 mm
75 mm 150 mm
English
2