Operation - Schon 67636-0191 Use And Care Manual

Installation (continued)
7
Making the waterline
connections
□
Thread the nut (1) on supply line onto outlet of
water supply valve (2) and tighten with wrench.
Do not overtighten.
2
H

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is completed, turn on the
hot and cold water supplies. Check for leaks.
□
Pull the hose assembly out of the spout and
remove the spray head by unscrewing it from
the hose in a counterclockwise direction. Be
sure to hold the end of the hose down into the
sink and turn the faucet on to the warm position
where it mixes hot and cold water.
□
Flush the water lines for one minute. This ushes
away any debris that could cause damage to
internal parts. Check for leaks.
□
Re-tighten any connections if necessary, but do
not overtighten. Reinstall the spray head by hand
tightening it back onto the spray hose.
1
C
8
Remove the quick connector
□
If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.
Squeeze
1
7
Please contact (800) 880-8164 for further assistance.
2
Pull
down
1
www.schonsimplymodern.com