Advertisement
Quick Links
Advertisement
Summary of Contents for PowerTek PowerJack
- Page 1 PowerJack Installation Manual...
- Page 2 Technical Information(STA) Dimensions Frame Side&Door Side: Atype:131x25x37 mm Btype:195x25x50 mm Use with Fail Secure/PTO Locks Only Input 600mA, 24V DC, powered by Class 2 or Electrical rating Class 3 power limited source. The length of connect cable is not great than 30m. Output 500mAƒ12V DC ƒ...
- Page 3 PowerJack Dimensions Atype Btype...
-
Page 4: Installation Steps
Installation Steps Step1: Survey installation site Requires depth of 47mm (1 7/8”) in both of frame and door side Step2: Location Apply the templates on the door side& frame side, make sure door side& frame side are aligned. Align the central line on template Step3: Installation in wood door or frame a. - Page 5 Drill a hole for PowerJack of depth of 7mm*1 7/8”+ and diameter 25mm*1”+ in the marked place. c. Using wood chisel to even the wood on the edge...
- Page 6 Drill a wiring channel for connection to the device to be powered e. Put the PowerJack inside the pocket to see if it fits the pocket Make sure the unit and pocket can fit perfectly...
- Page 7 Step4 Installation in metal door or frame a. Drill M3 countersunk screws hole according to template b. Cut the marked pocket with metal rotary grinding tool...
- Page 8 Put the PowerJack inside the pocket to see if it fits the space d. Fix the M3 countersunk screws by metal gasket Make sure the unit and pocket can fit perfectly...
- Page 9 Step5. Voltage Selection and wiring a. Select output voltage of 12V or 24V by adjusting indicated switch (Voltage adjustment only required to adjust door side) b. Supply output 24 VDC to frame unit. Connect red wire to positive(+) and black wire to negative(-) c.
-
Page 10: Power Supply
d. Sensor Wiring Diagram +[RED] SWITCH #1 [BLUE] Power Supply SWITCH #1 [GRAY] - [BLACK] SWITCH #2 [YELLOW] SWITCH #2 [WHITE] Momentry Open (3 seconds) [GREEN] Common [YELLOW] Hold to Open(max. 90 sec) [BROWN] Door Status [BLUE] Door Status [GRAY] Error Status [YELLOW] Error Status [WHITE] OUTPUT... - Page 11 Step6 Mount PowerJack a. Wood: use wood self-tapping screws b. Metal: use M3 countersunk screws...
-
Page 12: Fcc Warning Statement
This device has also been evaluated and shown compliant with the IC RF Exposure limits under mobile exposure conditions (antennas are greater than 20cm from a person's body). POWERTEK HARDWARE CO., LTD. sales@pt-hardware.com No.119, Hexiang 6th St., Beitun Dist. 40642, Taichung, Taiwan R.O.C. Tel: 886 4 24376707 The copy right is for PowerTek use only.
Need help?
Do you have a question about the PowerJack and is the answer not in the manual?
Questions and answers