Braun MG5090 Manual page 15

Adjustable comb (8): This attachment is ideal for beard trimming and
keeping it at a constant length.
• Place the attachment onto the shaver foil (2) and set desired beard
length. Press beard length selector (7) and slide it up (f) (possible length
settings from top to bottom: 1.2 mm / 2.8 mm / 4.4 mm / 6 mm). Push up
the twistable trimmer (4).
• Press the on/off switch and trim against hair growth by guiding the flat
comb part over the skin (f).
Precision comb (9): This attachment is ideal for trimming eyebrows
(ca. 3 mm).
• It is recommended to place the 3-day beard comb & protection cap (1)
onto the shaving foil (2) (e) when using the precision comb.
• Place the attachment onto the extended narrow trimmer (4b) (g).
• Turn on the shaver and trim against hair growth (g).
Cleaning
Regular cleaning ensures better shaving performance. Rinsing the shaver
head after each shave under running water is an easy and fast way to keep
it clean:
• Switch on the shaver (cordless) and rinse the shaver head under hot
running water until all residues have been removed (h). You may use
liquid soap without abrasive substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next, switch off the shaver, remove the shaver foil and the cutter block.
Then leave the disassembled shaving parts to dry.
• If you regularly clean the shaver under water, then once a week apply a
drop of light machine oil onto the trimmers (4a, 4b) and shaver foil (i).
Alternatively, you may clean the shaver using the brush provided (j):
• Switch off the shaver. Remove the shaver foil.
• Using the brush, clean the cutter block and the inner area of the shaver
head. However, do not clean the shaver foil with the brush as this may
damage the foil.
Keeping your shaver in top shape
Replacing the shaving parts
To maintain 100% shaving performance, replace your foil and cutter block
at least every 18 months or when worn. Change both parts at the same time
for a closer shave with less skin irritation. (Shaver foil and cutter block: 10B)
15