Advertisement
COMPONENTS
NATURE'S INSTRUMENTS NI-PG-301-01 POST MOUNTED CHALKBOARD PANEL. NI PACKAGE INCLUDES:
89 x 89mm [4"x4"] CEDAR POST:
·
PRE-ASSEMBLED CHALKBOARD PANEL:
·
PAINTED BOTH SIDES, FRAMED IN CEDAR TRIM
··
203mm [8"] Ø CONCRETE SONOTUBE FOOTINGS ARE NOT SUPPLIED.
PANEL INSTALLATION
1.
FASTEN THE POSTS TO EACH SIDE OF THE CHALKBOARD
PANEL USING SUPPLIED SCREWS FASTENED THROUGH
PRE-DRILLED HOLES IN THE PANEL FRAME (FRONT &
BACK).
2.
TOP OF POSTS TO BE FLUSH WITH THE TOP OF THE
FRAME.
3.
FASTEN THE BASE-'T' TO THE BOTTOM OF THE PANEL
USING SUPPLIED SCREWS THROUGH PRE-DRILLED HOLES IN
THE PANEL FRAME (FRONT & BACK).
3.a.
BASE-'T' TO BE FLUSH WITH FINISHED SURFACE.
FASTEN CAP TO THE TOP OF THE PANEL USING
SUPPLIED SCREWS THROUGH PRE-DRILLED HOLES IN
THE PANEL FRAME (FRONT & BACK).
4.
IF INSTALLED AGAINST A WALL OR FENCE, THE CAP MUST
BE FLUSH WITH THE BACK OF THE PANEL FRAME WITH
25mm [1"] OVERHANG ON BOTH SIDES.
4.a.
IF INSTALLED FOR CIRCULATION ON ALL SIDES, THE
CAP CAN BE CENTERED ON POSTS FRONT TO BACK.
FLUSH WITH
FOOTING SECTION
CHALKBOARD PANEL: POST MOUNT
COPYRIGHT © 2018 NATURE'S INSTRUMENTS. DO NOT SCALE DRAWINGS. NOT FOR COMMERCIAL USE OR REPRINT WITHOUT EXPRESSED WRITTEN PERMISSION FROM NATURE'S INSTRUMENTS.
℄
FINISHED
GRADE
0.00m
[+0"]
TOP OF
FOOTING
-0.10m [-4"]
CAP
POST
FRAME
BASE-'T'
FINISHED
SURFACE
FRONT ELEVATION
CHALKBOARD PANEL: POST MOUNT
PRODUCT NUMBER
NI-PG-301-01
PAGE
1 OF
1
PRE-ASSEMBLED CEDAR BASE-'T':
x2
·
x1
38 x 140mm [2"x6"] CEDAR CAP:
·
1
64mm [2
·
2
5.
FOOTING HOLES TO EXTEND BELOW THE FROST LINE FOR
YOUR REGION; 914 - 1220mm [36"-48"] BELOW FINISHED
GRADE.
6.
PLACE THE POSTS (ATTACHED TO THE ASSEMBLED
PANEL) INTO PRE-DUG HOLES:
6.a.
ENSURE BOTTOM OF BASE-'T' IS FLUSH WITH FINISHED
GRADE OF SURROUNDING SURFACES.
6.b.
LEVEL THE PANEL LEFT TO RIGHT.
7.
FILL SONOTUBES WITH POST-MIX CONCRETE AS PER
CONCRETE MANUFACTURER'S INSTRUCTIONS.
8.
FOOTING TO BE NON-VISIBLE; TOP OF CONCRETE TO
REMAIN AT LEAST 102mm [4"] BELOW FINISHED SURFACE.
9.
FINISHED SURFACE AROUND THE PANEL MUST BE LEVEL
FOR THE ENTIRE LENGTH OF THE PANEL.
10.
FOLLOW ADJACENT SURFACES DETAILS.
11.
RESTORE ADJACENT SURFACING TO PRE-CONSTRUCTION
CONDITION UNLESS OTHERWISE SPECIFIED.
2667mm [105"]
2527mm [99 1/2"] O.C.
INSTALL DRAWING
SCALE @ 8.5x11
1:25
"] BROWN DECK SCREWS:
DRAWN
CHECKED
PHONE NUMBER:
PR
DR
1-877-733-7456
x1
x1
x36
℄
Advertisement
